Recent content by Lapooa_338

Very interested in these If they are still available! PMd

Probably resurrecting this thread from the dead, but I designed and printed this myself, and have since changed it out for a real switchpros :nerd: As a side note, I wanted them mounted up high so the red backlight would double as a "nightvision preserving" maplight for the cockpit

Here’s my sunglass mount solution

I just saw this thread, interested in the 03 LT version. Is it too late to get in??

Camping at my secret spot [emoji6]

Depends on how viscous the oil is when it’s drained and how long you let it sit too

I had the same desire to carry some rods but needed something that would handle rough roads so I designed custom rod mounts with my 3D printer to replace the rear hooks

Made a few more adjustments after this version. Direct bolt in. Edit: Just realized this is the 3rd gen forum, Do you guys have a mounting hole like this?

I have the voliant intake, The previous owner put it on but I will be installing the stock Intake system because I trust the stock paper filters more than the cold air intake cotton cone filters. Sounds great at WOT, But since I offer Road and Dusty environments often, it’s not worth it for me

I have the nex 5200 but if I wanted a head unit today,I would get this. YouTube It seems like it would fit perfectly!

This is great! I wish the fourth GEN had more 3-D printed files

Never experienced this problem myself but I know the wiper will cycle once if it’s set to intermittent and the rear window is slightly ajar. Alternatively you can lower your rear window prior to starting until you solve the root cause

Bookmarked. I may have a 3D printed solution in the works

I’m not sure about the laws in Colorado but in California full-time four-wheel-drive vehicles are exempt from Dyno smog testsAnd are just tested on tail pipe emissions

I noticed you had a S Bend in your fuel line, I heard that here oil can condense and plug the line in cold conditions if enough gear oil is accumulated