Recent content by Late_Night

Better Late Than Never Oil Temp and Oil Pressure Sensor Mod A little late to the party, but here is where I added oil temp and oil pressure sensors to my 2002 4WD with 5VZ. I removed the passenger side tire, spray skirt, and oil filter to get access. The before photo, shows the two 8mm hex...

Updated: 2. Crankshaft Position Sensor - 90919-05021 5. suction tube assembly 77203-35660 with tank pressure sensor 89461-35010 6. Throttle position sensor (no OEM available for 01-02 except Aisan W0133-2744128) 7. 6 Fuel Injectors - 23209-62040 - need new pintel caps 8. Vapor Canister Purge...

Rando 2002 4Runner Parts Hey all, gotta bunch of free items from recent works, some better than others, will prolly shit can it in the next few weeks if no needs. FF (For Free) NorCal-North Bay or Shipped - Free Random Parts From My 2002 3rd Gen

Additional fuel injector images...

Last photo

More photos

I am a sucker for "preventative maintenance" and replacing parts BEFORE they fail, as well as some other items. So all free for local pickup, or you pay shipping. Please get what you need or have a plan for. Pickup area is NorCal - North Bay. Donations welcomed Everything was working...

Sucks those codes keep popping up. If you decide to replace the canister, Parts Geek have Aisan charcoal canisters for a good price, P/N W0133-2036358. I installed one and it had a black sticker covering a Toyota P/N and badge on it. Toyota 77203-35660 comes with a fuel tank pressure sensor...

Many thanks negusm for this post, VERY helpful and good advice! Just finished tank drop fuel delivery / charcoal canister replacement. There were no codes on my truck, but at 22 years old, I am replacing items like these. Totally agree with the points negusm makes with the parts lists if you...

Thanks for the heads up, going to have some brass 8mm/10mm nipple adapters ready for the mixed size hoses. Otherwise, I bit the bullet and ordered OEM hoses, not all of which are available, so there will be some hose rigging. Will report back on sizing for my CA 2002.

Hey, going to replace the hoses too while doing this on my 2002, you get the sizes figured out? It mentions 6 mm and 8 mm earlier in the post... I measured the OD of some of the hard line to hose tubing and it was all over the place, like 6.5 mm - 10.5 mm... :crazy:

Maybe magic! Yes, previous post was noted, appreciate the info, and I always trust but verify. The alt is 27060-62160-84 and I fried the rectifier a few weeks ago, then replaced it with an aftermarket rectifier. Running 2 awg wires. Nothing too radical.

Yeah, I installed one, but the cold idle voltage was close to 15 volts so I took it out. Cold idle without the diode was around 14.5, so I am going to check the "hot" charging voltage and see if it is below 14.8 which is the max charging voltage recommended by East Penn for their AGM...

Good point, pretty much settles it, CS144 it is. Luckily Denso makes a version.

Yeah, the idle output of the CS144 is enticing... I am going to order a 50mm pulley for my OEM alternator in the mean time. Did you need a shorter belt when you put the smaller pulley on your alternator?