Recent content by LonestarRunnerTX

really jealous of the original interior haha

Thanks, it will make a world of difference when I build a bumper later! Really need to toss the body lift and do the suspension.

This week I repainted the grill and badge, I went ahead and got all the new grill clips from the Toyota dealership, I think they ran $1.95 each. After I reinforced the front crossmember and did some mods to the old smitty front bumper. I plan on building new tube bumpers for the front and rear...

I installed the new weber carb and regulator, carb is receiving 2.8lbs of pressure.

Last week I removed the old carb and did an EGR delete with LC Engineering block off plates.

Thanks, I think so also, the 33x10.50s look perfect on the 1st gen. I will be posting several pictures over the next few days.

The po swapped a low mileage 22r out of an 84 hilux into the 87, she runs very well after adding the weber carb, I am located in Corpus Christi and the Spring area of Houston, just depends on what time of year haha. I am slowly getting it the way I want it!

I have made a lot of progress over the past several weeks. I put all new brakes on the front and back. Replaced the seals on the hubs and replaced all the diff fluids. I installed a new fuel pump and brand new weber carb. After doing research the 22r that was swapped into the 87 was from a 2wd...

Finished the tires today. Sprayed 3 coats of primer, 3 coats of new ford grey and 2 coats of clear coat. I am liking the look, reminds me of the steelies on the FJ40s.

While waiting for the carb I also picked up some old steelies off a 1991 Toyota pick up. I am selling the wide 33x12.50 and mounting 33x10.50. I am just not a fan of the wide look. After getting the wheels I had them sandblasted and have done 3 coats of primer using great dane. It is some great...

After putting in a new battery and terminals, I checked the timing and checked fluids. I got her started and found a bad exhaust leak at the base of the exhaust manifold. I decided to tackle this while I wait for my Weber carb to come in. I plan to do new exhaust down the road so did a temporary...

I am calling this the Roll Tide build because I picked her up in Alabama. Here is the day I picked it up.

Hey everyone, I have been lurking on here and getting some ideas. I recently bought a 1987 4runner and will be doing a overland type build. This thread will be picture heavy!

I will be selling the front and rear bumpers soon if anyone is interested. Sent from my iPhone using Tapatalk

Picking it up from Alabama today and headed to Texas. Sent from my iPhone using Tapatalk