Recent content by lonewolf98765

1st gen Missing the 1st gen.

Susie Still proudly have this beast, owned it since 2013.

1988 3vze sr5. Started with the zuk mod and I couldn't help it. I blew the clutch replaced it, flywheel when bad 5000mi after the clutch went bad so she cake apart again. 5000 miles before the clutch was the head and head gasket, Chevy knock sensor and new upper gaskets. Then my afm went bad so...

88' Message for more pics

Selling 1988 4runner have had her for a few years now and have decided to move on. For more pictures or information PM me or email me. 5spd sr5 V6

Not bad, this was $600 with a beat body but solid frame and floor pans. it's a twenty foot car

susie just a few more, edit: soooo why did it do that to my pics

Susie 1st Gen since I was 14 :pop2:

I mean yeah I could do that but I could also just lift my chevy... but what would be the fun in that? I got the tires spaced out 2.5" per side, running 16" rims from a 2000 sr5 on 31"s When these tires are dead I'm putting on 33"s and the 31s still rub so she has to go up

Alright, When I first started on here I felt like a noob because I was fourteen. Now 6 years and many extensive repairs later I ant to finally get the front end up. I went full balls when I did the zuk mod so I have about 3-4 inches of lift in the back. Maybe along the lines the torsions...

:smokin:My baby Sue repainted from garnet red to camaro rally yellow :bounce::bounce:

Alright, I have a 1988 Sr5 V6 factory height with some nasty butt sag so it's butt is hangin down at only 33" off the ground. I would like to get 33" on there by doing a 2" block lift under the leaf springs. But would doing an add a leaf also help me?I just want to have it all set up and I'm...

It does, it always runs for a few minutes solid and now it just dies could it be a fuel pressure regulator??

I've had my 4runner for about 10 months now and I've done a lot to it. I did a general tuneup in the winter and after that the engine started freaking out, it used to idle kind of high but then would drop down, no0w it idles at about 1,000 rpms, and it has a slight miss (any suggestions on...

Make sure everything is tight! The guys i bought my 4runner from, they were messing around cause it didn't work and they left something loose here and there. If the arms/ cranks / or gears aren't tight they will slip. Lemme know if that worked?