Recent content by LuvDLions

That's my buddy out here in Yucaipa. He isn't on the site here, I just invited him out. Glad I did, he made sure to stay with me as I limped home on a broken drive axle. -

A little bigger pic, I hope -

Bryce - :happy bda Here's why I had a shake above 60 on the way up there, slippage in the snow, trouble getting up that little hill and all of the noise once we hit the main road. My buddy, Vince said the front wasn't spinning on that little hill but it did on the power line hill, so it must...

My buddy and I live in the Yucaipa area, so I was contemplating finding a trail from Arrowhead to Big Bear (I don't know one, but I am sure there is and I have a map, so I'll wing it) and then down Skyline/Clarks grade to Angeles Oaks from there and take the 38 home. If we do that, it will...

Damn, that's a good idea. I should try to get mine hooked up before we go.

INS: EL GRINGO LOCO PIMPSTA ME MY PLUS 1 MAYBES: RYHI GIGERUNNER KEEMONRUNNIN Anyone else? ---

I just bought it. Besides all of the tune-up stuff I have done, I don't know much about it. It was a real dog when I first got it. I changed all of the tune-up stuff, adjusted the throttle cable and kick down cable and it is a little better of a runner now. (mine is a 93 3.0) It still has...

Air flow sensor ohmed out ok. When I unplugged it, it got worse. Wouldn't run at all. I tried looking into ohming out the tps but I didn't want to make things worse by removing it and not adjusting it right. Now that I read this, I am glad I didn't. Looks like I well have to check out the EGR...

I was hoping you would find something, because I am having the same issue. I will check mine tonight as well. Mine will start, idle for a second or two, start to stumble and then stall. I replaced the typical tune-up things (air filter, plugs, wires, oil, filter, fuel filter, pcv, cap...

I'm in and I am bringing another (experienced/extremely lifted) t4r with me. After running Angeles Oaks service road to Seven Oaks then up Clarks grade and Skyline drive last weekend I am ready. We had a little snow on Skyline! After that run I had to change the idler arm to get rid of the...

Welcome aboard! I am new here too and will also be going Saturday. See you there!:thumb: ...

It's good that I did it, but what a P.I.T.A.! I read on here that you have to take off the intake, but I read somewhere else you can do it without reviving it, si I tried that first. Long needle nose pliers a long crowbar and some vise grips got it out. Had to pull the old hard brittle grommet...

no playoffs for us, we lost, so I may be able to get all of the repairs done this weekend and join you. I may even bring a buddy or two. 1 4runner, 1 XJ. We'll see. Luv

That's a possibility, I think the dog already started chewing on one the rubber end caps. My wife left them in the garage because it was too cold and there you go... PM me. I have also seen about 5-6 4runners at the Ontario pick a part and from thurs-sun everything is 50% off. ....

If that is your rig in the picture, you will be able to do it no problem. There's probably a little snow up there now though. ...