Recent content by maclean216

Good guide. I just would not compare TRAC of this generation to a front or rear locker. Just my 2 cents after 24 years of ownership

I hear the URD one works great.

Glad to see you still owning and working on the rig Brian. Looking good as always!

What's your tire pressure? I would air down a bunch.

Right now I'm using the Land Cruiser coils that come in the Sonoran Steel 1.2 kit.

2001 4Runner oxygen sensor mystery Found the answer here. I will report back if everything works and I pass smog.

Front: Sonoran Steel Bilstein 5100 coilovers complete with all Toyota parts and hardware Rear: OEM Land Cruiser shocks as part of the SS 1.2 kit Asking $200 for everything. Located in San Diego, CA. I also have the SS 1.5 rear links for sale if anyone is interested.

Installed Bilstein 5160s and pulled out my Sonoran Steel 1.2 Land Cruiser shocks. I drilled out the shock mount for the install of OEM LC shocks, and obviously the top washer on the lower bushing is too small on the 5160s. Does Bilstein or Toyota sell a separate busing kit? Anyone else run into...

Bought the Flowmaster California direct fit converter (rear one) (Part #910153)and instead of the M18 screw in O2 Sensor bung, it has the two studs for the O2 bung attached with two nuts. Is there another CA O2 sensor that would work for a 2001 CA Toyota 4runner or do I need to weld a bung(funny...

Do the harness and both knock sensors. Only use Toyota oem parts. Mine went out at 250,000. Only use Toyota parts for this. It isn't that difficult of a job just time consuming

I wouldn't go with the 5100s. I went broke 3 of them. I'd go 6112s or save up for something else. If you never intend to go off-road then nevermind.

Replace the harness and only use Toyota knock sensors.

Steve used to sell modified UCAs to clear 35s. Not sure if he does anymore or not. SS sells a very nice suspension system (1.2)

I have SS 1.2 front coilovers for sale.

3rd Gen 4runner stock lower links. One is bent. $100obo. As is. I am in San Diego.