Recent content by MARSHALLMAY

yeah, the wife took those, she must have had the settings off

Padre Island Natn'l Seashore. Almost 70 miles of soft sand.

You'll have to run a wire from the headlamp relay to the fog light relay so the fog light relay is energized when the headlamps are on. I'm not sure which posts are the right one. Process of elimination shouldn't be difficult. my previous post is wiring them independent of anything else...

jump a wire from your fuse box below the switch to the post where the purple wire goes on the switch. I just did mine. They will only be able to be switched on when your key is turned.

if you have manual controls, just pull off the knobs and fan speed piece and then pull the bezel off. No screws to remove.

This Might be your easiest route.

You don't need anything, but I added 2 ome 5mm trim packs on each side up front to help level the ride. I also did a ss diff drop which is not needed, just a little insurance to protect the cv's.

I have the ome "heavy duty" lift. 881 springs front and 890 springs rear. This suspension outfit drastically improved the ride quality. The lift did not cause the truck to have excess body roll or "lean" during cornering. In fact, the stiffer springs made the body roll less. Handling is...

i was side swiped a while back by a tacoma. It damaged my rear passenger door and it was entirely his fault. I was able to get his insurance to pay for an entire new door skin rather than pulling the dents and using bondo. I don't know if they did that out of the goodness of their hearts. In...

my 98 ltd has 16s and yes the calipers and rotors are bigger than sr5 and base models. The only way to fit 15s is to grind the caliper to clear the rim. You have to be careful doing this. And I can't recommend how to do it.

i think you need to do some more research on caps. They could drastically extend the life of your battery and alternator. read all about caps the "like a water tower analogy is excellent."

maybe fan clutch? With the engine off, try to spin your fan by hand. If it spins very freely the fan clutch is bad. It should have enough resistance to where it won't spin. If that's not the problem try what the others are posting...

Yeah I was wondering what was going to happen, but the ground was soft. Yaknow, it's amazing how photographs make the incline look much less spectacular than it seemed. Although, if I had an inclinometer, it would also tell me that i'm not going high enough. I would have cased the top if i...

I was on the way to a friends' superbowl party and saw this. It's the entrance to a new neighborhood. They did a lot of work to cut out that hill. a lil sway bar induced tripod...

I had a nighthawk for lunch today... yummy