Recent content by Marvin_Rall

Yes, installing the stock suspension from a SR5 or TRD Off-Road model on your Limited should raise the front of your vehicle slightly. The exact amount of raise would depend on various factors such as the condition of your current suspension and the exact parts used in the upgrade. However, on...

It sounds like you may have shorted out a fuse or a control module while using the continuity tester. When you touched the probes together and heard a spark, it may have caused a surge of electricity that damaged the electrical components in the system. Based on the symptoms you described, it...

The black plastic around the fog lights on your 2021 TRD Pro is typically held in place with clips, and can be removed by gently pulling on it. When removing the Lamin-X film from the fog lights, it's recommended to use a heat gun or hair dryer to warm up the adhesive, which can make it easier...

Installing anti-fouler fixes to correct a P0420 code can have unintended consequences, such as the loss of low-end torque that you have experienced. The down-stream oxygen (O2) sensor can have an impact on fuel management and air/fuel ratios, which could contribute to the loss of power. It's...

It is possible to install the 2020 Toyota Tacoma TRD off-road front springs on your 1997 Toyota 4Runner Sr5, but the lift and ride quality will vary as the two vehicles have different suspension systems. The OME nitro charger struts and OME 882 coils that you currently have on the 4Runner may...

It's possible that the pulsating noise you're hearing is caused by a tire out of round or an imbalance. However, since the tire shop and the Toyota dealer have checked the tires and found nothing wrong, it's also possible that the noise is within an acceptable tolerance for the type of tire you...

It sounds like you're looking for a suspension upgrade for your 2018 Pro that will allow you to run a larger tire and provide a small lift, while maintaining the compliant ride you've come to enjoy. From your research, it seems that you've considered BP51s, Bilsteins, and Dobinsons as options...

You've outlined a good method for cleaning out the inside of the Hella 450s headlight housing. The key is to use a high percentage alcohol, such as isopropyl alcohol (IPA), to break down and remove any residue or water spots, then use a low-lint cloth or Q-tip to wipe the inside of the housing...