Hello friends,
I need some advice on a coolant leak that I have found. The coolant is dripping from near where the heater hoses attach to a manifold that is bolted to the back of the engine block. I can see three metal pipes on the manifold that the heater hoses are hooked up to. The middle...
After replacing my drivers side exhaust manifold and cat assembly on my 2004 V6, I immediately got a P0051 code when I started the engine. I did not replace the sensor but this code was not present before I did this job. I didn’t see a readout in my scan tool for the A/F sensor voltage, but the...
I’m getting a P0430 CEL for bank 2 catalyst efficiency. Replaced the O2 sensors with Bosch and still have the code. Here is two screenshots of my O2 data. Can anyone make heads or tails of this?? Photos attached.
Thanks! What a headache to diagnose!
I pulled apart the front door panels and tightened the retaining bolts for the window. The passenger side would rattle, especially when closing the door. Turns out, the forward bolt was unthreaded to the point of nearly falling out. Tightened that up and greased the tracks.
Continuing work on...
I actually think that mock-up looks really sweet. I’m partial to the steering wheel in my 4th gen, but as far as modern wheels go, that design looks pretty solid.
After I replaced my power steering pump, the belt was squealing like crazy. At first I thought I bought a bad pump, but it turned out the belt was one rib off center from the water pump. Doesn’t hurt to check that the belt is aligned over all the accessories before you go buy a new one!
I'm in the process of installing an Alpine ILX-W650. Didn't realize there are two antenna cables I have to get a y connector for. Hopefully configuring the steering wheel controls to work isn't difficult! Good opportunity to replace burned out lights in the dash too... except they don't arrive...