Recent content by MCS175

My 2011 SR5 had a little run-in with a deer a while back, and wound up getting a steel front bumper and fixing any other assorted damage myself. I ordered a non-OEM grill since I was going to paint it matte black anyway, but the emblem was not a part of it. As far as I Can tell, Toyota doesn't...

I've got a few pics from the last couple months, still getting the damage fixed from my last little mishap. These first few were from my fun, but uneventful trips This was from when I tried a mud hole that was too hard, got stuck for 3 hours and had to get pulled out And this was the...

I put 9x17s on mine with a -12 offset. Did a lot of research, and anticipated at least pushing the liners foward, most likely bumper cuts (absolutely needed), and likely BMC. Its good for street driving now, but will need the BMC to get any travel before i do any off roading. 33x12.5s are...

There's a lift, the Toytec Billstein 5100 kit. I had 275/70/17s on there before the lift, and now I've gone bigger (finally). Right now no rubbing except for just a little at right lock, may trim a little more off the driver's side liner.

Managed to stuff some 33 x 12.5 x 17s on my 2011 with minimal trimming, so far... Replaced the factory spare with a 5th on a Wilco hitchgate. Now onto touching up the blacked out chrome strips and painted emblems.

Awesome, let me know if they turn up, thanks!

So I just got a set of OEM mudguards PT769-89110. Got the rears installed without too much trouble, knew the fronts could cause trouble with the running boards. Deicded to try and trim the passenger side front with pretty awful results :redbrick:. Should have done some more reading on here and...