Recent content by mikegronholz

Thanks. It’s been a fun build!

Just black metal stamped pieces. No idea what’s on an SR5. Sorry

Front - OME 2885 w\OME Nitro Sports and SPC Arms Rear - OME 2895e w\ OME Nitro Sports and OME 10mm trim packers Trail Gear Diff Drop 285/70-17 BFG KO2 on MK6 17x8 -10

Here's Bessie. OME 2885/2985e with trim packers on OME NitroSports, SPC arms, LEDs, Pro valences with 285/70 BFG KO2s pulling the anchor baby for the maiden voyage.

I have some TRD OffRoad ... non Pro's I can part with I suppose.

And since this is the MK6 thread, here's my heep and my exped trailer.

If not I’ll just buy the Toyota ones and rattle can them black. Or ... I’ll buy the trd ones and trade someone. I’ll buy someone a set of 4 Toyota TRD ones in fact for tradsies.

Been there, done that. Stupid expensive.

Anyone have a pair of black level 8 center caps I can buy?

so with 3" lift and 285 BFG, what's the consensus for no rub ? -10 or 0 ? Everyone with this setup doesn't list their offset.

Cool thx. The springs will be new as I need softer than what was run. I was more thinking the perches were mounted higher/lower. Either way nothing a top plate can’t correct I suspect or the OME bottom trim spacers.

Have some aftermarket 4th gen suspension components I’m gearing up to put on. Getting cleaned up. A passerby mentioned i should not expect to get the advertised ;th gen height on a 5th gen ... maybe an inch less. Hadn’t read that in any research. Any merit or experience here? All OME coils...

Yeah. Found a couple for 350-400 but didn’t want to get the “don’t low ball me”

Still have all this ?

still have OME goodies ?