Recent content by Milo99

I have a 2013 4runner that had a sunroof leak. The water mostly ran down the driver side A pillar and damaged the body control module. I was unable to get one of these from Toyota, but did get one from a used parts dealer. Replacing it restored all of the functions of the vehicle except the...

Bronco 2 door Bronco with the manual Trans. I like jeeps, but the build quality is awful. I had a 2006 LJ 4.0L. It was the last reliable engine they made. I would have never sold it if it had a manual, a hard top and more power. The new Bronco is exactly that.

1st year is a no I wouldn't buy the first year of any new drivtrain, much less a whole new design. If they come out in 2027, 2032 is probably when you want to start looking at them.

Key programmer I just bought an Xtool D7 scan tool from Amazon. It was $360 after some rebates. It can supposedly program smart key fobs. I went through the process and it looks like it would work. It didn't work for my issue, but that is another story. It should be easy to program a...

Brake drag The bigger issue I have seen with brake calipers is not evenly clamping. The piston is well protected by a boot, so it moves, but the outer pad has to move on the sliding pins. If they seize, the inner pad pushes on the rotor but the outer one doesn't. This makes the inner pad...

Plexiglass I mounted a dash camera to the end of a sheet of plexiglass. I just stick it above the passenger side sun visor so it sticks out the front. I could use a longer piece of plexiglass and mount the rear camera so it looks through the whole cabin toward the back. I know this isn't...

Made a coin holder to fit in the console My 2013 has a place to hold some quarters, but I wanted a full compliment of coins for some of those tolls. It's 3D printed in PETG.