Recent content by Mitsuboost30

Got it. Did you use the pump to lower the pressure or bleed it out? Instructions are pretty straightforward, I, unfortunately, suffer from overthinking everything LMAO Thank you! :cheers:

Finally got around to building the pump and bleeding the system. All worked well. Im stuck on the instructions. Am I reading this right? Bleed all parts to 1015psi. Then back down the pressure based on this fluid temp chart (attached), 415-420psi?

Gotcha, not sure why I was thinking that was a different fitting. So the nipples on the system are standard r134a HVAC connectors? Thank you!

Okusputokus Did you ever figure this fitting? I am going through the KDSS clunk now and building the SST out to swap the cylinder. Thanks for your info!