Recent content by mnorm757

Been sifting through this topic. I have a 2008 V8 4x4 (232K miles) that's has the beginnings of the rumble strip symptom taking place mostly between 1500-2000rpms. I had the transmission fluid drained and filled a few weeks ago. I'm wanting to buy a few tubes of the Shudderfix and give it a...

LOL...never mind.

Anyone have any advice or insight? Again, I appreciate any help...I'm trying to avoid throwing money at unneccesary things. This is unlike any other vibration I've had (wheel bearings, bad CV, bent rim).

On a bit of a wild goose chase.... Getting a light vibration in the gas pedal/floor board between ~20-40 mph/1500-2000 rpm when accelerating. I lifted the front slightly with 5100s to level out the truck after deleting Xreas about 5 months ago. I cleaned the throttle body yesterday and noticed...

Sorry to drag up an old thread but I'm on a wild goose chase.... Getting a strange vibration in the gas pedal/floor board between ~20-40 mph when accelerating. I lifted the front slightly with 5100s to level out the truck after deleting Xreas about 5 months ago. Could this be the needle...

Two questions...appreciate any advice.... In a few weeks I'm removing the Xreas system on my '08 Limited V8 and replacing with Bilstein 5100s in the front and 4600s in the rear...keeping the rear airbags as they're working great and in very good condition. I'm planning on raising/leveling the...

I'm familiar with those codes as I installed the Slyfox bypass kit a while back. I was getting these almost daily and have not had a single issue since installing the kit...until this. I took the truck to Autozone and my battery was not even at 1/2 power...it was over 5 years old. Something...

Apologies for dredging up an old post but I can't seem to find the answer... This morning on the freeway the dash lit up with the Check engine, VSC, TPMS lights all illuminated and the truck felt like it went into limp mode. I have the Slyfox bypass kit installed. I cleared the codes (P2445 &...

I've had the Slyfox bypass kit for about 18 months and the exact same thing happened to me on the freeway this morning. Temp went down to 17 last night so I'm hoping this may be the culprit. I cleared the codes (P2445 & C1201) once I got to work and the truck seems to be driving normally. One...