Recent content by Mojo29

So I accidentally drilled through some wires on the drivers side radiator core support (right in front of the battery). As a result some of the wires that were in a wire loom got severed. I spliced them back together and now my ABS light is on in the dash. All this happened when the vehicle...

Can you run OME 881 front coils with the Tokico Trekmaster front struts?

Went to the dealer today and hopefully ordered the right part. The guy at the parts counter was pretty clueless. I literally had to show him the correct part I needed because he had no clue. He kept tying to tell me it was the dust cover I needed. I pretty much told him that this is not...

So I changed my Lower BJ's last week and today I noticed the front driver's side axle seal leaking where the CV would enter the front diff. I've tried to find some part numbers on here but have had no luck. Does anyone know the part number or the correct term for the seal? Is this easy to...

I do have 2 cats. The exhaust from the drivers side runs behind the engine and then ties into a y pipe into the first cat. It then runs to the second cat along the passenger side. I did manage to unclip the sensor from the harness which is a pain and I compared the harness to the cali version...

Looked at the door sill and it didn't say squat. However under the hood there is a sticker that reads " This vehicle conforms to the U.S. EPA NLEV regulations applicable to gasoline fueled 2000 model new LEV light duty trucks and to california regulations applicable to 2000 model year new LEV...

I think the correct part number and this is for the O2 is Denso 234-4162. The Autosone code reads P1130 "air fuel sensor circuit range/performance" and P1135 "air/fuel sensor heater circuit response". Not that I trust Autozone because the guy who scanned it said it a temperature sensor located...

On the Denso site there are air/fuel sensors and then O2 sensors which is the correct one? I thought that they were both the same thing? Does anyone have the part number for the upstream bank 1 sensor? Kinda gettin confused...

Exactly

Thanks Durk. Gonna order one from rockauto.

I saw the Denso O2 sensor on rock auto.com for about $60.00. Would the pre cat sensor be considered upstream or downstream? I'm guessing upstream.

My check engine light came on today and Autozone pulled 3 codes. The first is PO125 and there are two "old" codes P1130 and P1135. From reading some posts here I'm guessing that the PO125 is the O2 sensor? Every post I read says its the bank 1 sensor. Is this the first O2 sensor on the...

Did the load D tire ride stiff? What kind of suspension set up do you have?

Where can I purchase the LBJ bolts from? Or what is the bolts size? I've been looking to do mine but just need to get new bolts.

One of the biggest problems is the woman. She already complains it's not easy to get in there and I don't even have a big lift on (she is only 5'1). If I air down to 20 psi don't I run the possibility of blowing a bead without bead locks? Obviously I won't run that pressure unless I'm off...