I did few. Nothing crazy, a bit of everything though. Some wooden trails, a little mud couple rocky trails, had them @20 psi. No issues but again it wasn't anything extreme. LT255/80 are nice however they can loose a grip on wet. I heard P rated have silicone compound and supposed be much better...
There is no problem using any LED bulbs in low beams or hi-beams. The only problem is a flickering of hi-beams in DRL position. Basically Toyota is using hi-beam bulbs and lower voltage. So when you install any LED bulb in a hi-beam they will flicker (barely noticeable but still) in DRL position...
I did DRL cancelation mod. Bought used DRL relay on eBay and bend one tab (contact). Just search for DRL cancelation.
But you can buy LED DRL module to prevent flickering if you want and keep em.
Yes, no issues at all. Good as the day they went in.
it is exactly same bulb as Supernova V4, same brightness , different finish with much better fitment due to matching mounting tabs used by Nineo vs standard used by Supernova.
I like F5s and have 2.25" lift already. Which backspacing you'd recommend for 255/80r17? I was thinking 3.50 to get wider stance and to avoid spacers. I don't mind doing bmc.
It's 52.36 lb based on below.
I didn't have a chance to weight the tire itself. But I did weight rim before I installed the tire and after.
81.48lb (mounted & balanced tire @ 50psi), stock 17 inch TRD OR rim 29.12lb (rim with some old weights on it).
No need to regear, as long as you stay below 34" or 60lb/tire, I think. Yes the odo is a little off, about an 1mile or 2% @62mph, which is less than 4.7% tire calculator shows.
Falken lists LT255/80R17 being 33.1" on their website.
I compared mounted and unloaded side by side with stock:
Height:
• Bridgestone Dueler H/T 684II P265/70R17 - 31-5/8"
• Falken Wildpeaks LT255/80R17 AT3W - 33-1/4", 1-5/8" taller than stock.
However, they are 32-1/8" tall (mounted on vehicle...