Recent content by moxley

PM sent.

Just got back from Colorado. I will check tomorrow and pm you

Just installed the Toytec Boss lift. I have 1.5 inch body lift. Fuel Hostage 17x9 with 33 inch Goodyear Duratracs. I want 35's now! Just finished the install so please excuse the phone pic!

Got the joint back together and finished the install. I cannot thank you all enough for your help! I appreciate the forum so much! Here's the after pic. I just wanted to share what you helped do!

Thanks for the help everyone! I found another thread where the spider "tripod" joint was pulled out. Can it slide back in easily? The boot is completely in tact. 1. Will it slide back in? The axle is only 2 years old. From what I have read on other posts it is easier to replace axle than...

Thanks! I do have a jack and will do that. I tried it earlier but probably did not raise the arm enough. That's when I was worried I broke the rule in the instructions to not let the axle drop too much and had messed up the axle because of the way the boot looks. I appreciate your help!

I am installing the Boss kit on my 04. I have the left front side done but have run into an issue on the from right (passenger). In following the instructions to remove the 2 bolts attaching the LCA to the Spindle assembly I must have messed something up. I got the new coil over in but cannot...

Here is a pic of all four. The link in the previous thread will provide more detailed pics.

I have 4 Sport wheels from my 04 4Runner. 17 inch. Good condition. $300 OBO for all four. I am in DFW, TX and prefer local but I will ship if you want to pay shipping from 76131. Here is a link to pics.

FS: Set of 4 - Sport 17 inch wheels I have 4 Sport wheels from my 04 4Runner. 17 inch. $300 OBO for all four. I am in DFW, TX and prefer local but I will ship if you want to pay shipping from 76131. Here is a link to Dropbox with pics.

I have a set of 4 in really good shape. I am in Fort Worth if you're interested in shipping.

I would recommend ordering the inner seal ($28 for 2 I think) that way you ensure debris will not get into the new bearing assembly shortening the bearing life. I did replacements on more parts when I had everything apart. Here is a thread showing the inner seal. Thanks to Austin (aha2988)...

I ordered a set with the inner seal. I replaced that to keep debris from getting into the new assembly. Very quick shipping and great response with help questions. If you need bearings, get them from here! I finished the install tonight. When I got into it over the weekend I ended up having to...

Try calling Rock and Roll off road in North Richland Hills. I have spoken with them about XREAS. The level kit will not cause any issues with it. I have a spacer lift and XREAS. Was the quote $250 just for install? It's not a difficult install for DIY.

I know this is an old thread but thank you for posting this information. I bought a new hub assembly with bearing and a new inner seal. The inner seal adds significant time to the job but good protection is worth it. I did find that I have to replace my upper ball joint and tie rod ends as I got...