Recent content by MrBruns

Old thread but curious if you have found a solution for this?

Stop bleed kit, paper towels, Jetboil, tool roll, mag pouch. Fire extinguisher, hatchet, molle pouch for winch controls, molle pouch for two 20oz Hydro Flasks, Morakniv,

I will be removing the top panel to mount an sPod. Did you have to remove one before the other or did you see or notice if you could just remove the top without removing the bottom first? Thank you

Off topic but are these still the Ray10 17x8.5 -10offset?

That's sh!tty. Sorry, I hope you found it. Theres a lot of wind noise from the wind fairing (the one that comes with it and mounts under the first crossbar) so I took mine off. Got nasty whistling and a bad vibration in the rear somewhere anything over 40mph. I put it back on that same...

I also have the full Frontrunner on the 4R. Considering the Gobi for mounting fuel so climbing on it I will not. I'm more interested in how much it hits the rack while the lift gate is open. Are you having issues with this? How bad if any? Thanks.

This is the exact spot I was thinking for the Yaesu FT-8900R. Looks to be the same size as the THT. How is it working out? Any issues with movement?

I was thinking of mounting the touchscreen in that same location. Not sure if the mounting bracket is the same. Is that way holding up for you or did you reinforce the bracket from underneath at all?

Just ordered these panels as well. Curious, could a ram mount be placed on the panels as well? Using rivnuts or just nut and bolt? Wasnt sure if the hikes in the panels match those on a ram mount. Thanks.

Ive seen this fuse box being an issue as well. Would love to hear or see how and where you moved that box. LFD makes a bracket for the passenger side I think will work for a compressor but the future may be bringing in a dual battery setup.

Were you able to get your hands on these? All I see on their site is "coming soon" I think these make a good alternative option from a rear bumper.

Are these still available? Their site keeps telling me coming soon. Not sure soon is ever going to arrive.

I got this idea from a few members so here it is. With the 2020 4Runners rolling out and the new DRCC sensor in the lower grill I'm sure there is some concern with aftermarket products that may interfere with this sensor. I personally have been looking into the C4 lo pro winch bumper with the...

I too had this question. Ive been running some tests with a pool noodle strapped to the front of the 4r. Ive had it as low as 2 inches below the Toyota garnish. No effect on the sensor. I gave this information to C4 with a response saying that this sensor wouldn't notice the pool noodle...

How are those XL Rokblokz working out with your 285s? Any pics by chance?