Recent content by MTBChris

Its a pretty solid design, retains the 7.5 fuse as well. Doesn't have the 3 settings like the ArchLight does but at low setting I was getting around 14.2 and 14.5-14.8 on the high setting. Its priced at $85, $4 flat rate shipping from the VoltageBoosterPro website. Gonna run it through its paces...

Thanks for posting this rigtec! I swapped out my OEM battery to an Odyssey AGM and didn't realize that a voltage booster was required. ArchLight didn't have any instock so I went with VoltageBoosterPro

Updates to the rear and finally got slidders on:

I know, I know....I need to get some sliders. Soon hopefully

Cleaning out the garage. These things need to go. Located in San Diego and will not ship: New Baja Designs Onyx6 dual control 30" light bar with harness: $1,200 5th Gen TRD PRO front valence: $100 Eibach 1" lift rear springs used for 600miles: $175.00 New 2010+ 4Runner King Front...

Updates to the rig: New wheels/tires and a front bumper high clearance cut. Some other new things added as well

Thank you sir. They are 285/70/17's

My grey:

you can get the case to sit snug on the cross bars but the case does shift side to side a little. That can be remedied by placing some rubber gasket material in between the mount and the slot the mount slides into

The mounts are just bolted into the bars using t nuts so they aren’t very secure. You can easily unbolt them with a 10 or 12mm. You can probably use those torx bolts with the pin in the center for a little more security but then again, someone can just unbolt the crossbars from the rack intself...

Its got decent real-estate, good for recovery and camping gear. I just mounted it so i haven't placed anything up there yet but I noticed the locking eyelets are tiny. Can't fit a normal size lock so I'll have to use something smaller. Something to think about when determining what to put up...

They mount to any extruded cross bar but I'm sure you can modify them to fit different racks. I have it mounted to my Prinsu rack. I actually had to cut off 4mm from the top of the bracket because they sit to high and prevent the case top from sealing correctly. After doing that its been solid...

Sherpa makes brackets for those cases without drilling: Sherpa Roam Case Mounts Thats how I mounted mine: