Recent content by mustbeme

Update: TPS/throttle body is continuously making noise and killed the battery overnight. Getting TPS code in scan tool. I can pull the blue relay (EFI) under the hood and she usually fires right up. I ordered a replacement TPS/throttle body I cleaned grounds, pulled fuses and clean and...

Just installed a new battery. Old battery looked old from prev owner and gave out after some ignition symptoms. Now New battery and: 1) Nothing in holding run position no noise buzz nothing 2) then starter will engage and I can let go of key and starter keeps going 3) Engine will crank and run...

Pair of brackets, L and R mount bumper cover to the front frame brace/bumper support. These are in good shape and straight. $15 plus shipping

Left and Right for lower bumper 3rd gen. OEM plastic housing. I have 1 lamp pig tail I will throw in. I pulled from a bumper I needed. $25 plus shipping

Free right front fender as shown. Located in Tryon NC also in the Upstate SC region

In Tryon NC. I bought this for my 1st gen then sold it. I purchased online. Said to be a working T100 DD brake booster. $50 + shipping.

1989 4Runner. Door jam sticker says manufactured in Aug 1988. Needs nothing. Turn the key and drive. Read my description below. Located in Tryon NC 28782 V6 Auto 4x4 with original manual locking Hubs. This is nearly a stock truck down to the FM CD changer audio. Body: I replace the rear...

Resurrecting this O2 Sensor thread Anyone use a particular replacement that did or did not work? I purchased the NGK but it does not resemble the unit that came out of my 1989 3.0L I see that the Denso looks closest to OEM I went with a Bosch and waiting to install

I have 1 each 4x4 Innovation Jerry can holders for scepter 5 gal can water and fuel. I only used to help model another part I am working on. They are like new Prefer to sell locally, they are heavy but I will check on a shipping quote for ground. Steel construction. Extremely well made with...

1988 V6 auto. 225K miles Daily driven. Most everything works: AC/Heat, lights, signals, rear power window, rear wiper, high low beams. All original FM cd changer which will eject and load but I gave up trying to get CDs to play. Crank windows, vent window function fine. Has owner manual and...

My holes lined up enough to start my hand. Ran them in with a 20V dewalt One caveat, I let my top sit on the truck for several weeks untightened because I ran out of time.

I have little knowledge of sheet metal and body work. Are there any fender arch skins available or what do we do for 1st Gen rust in the fender areas? Are there other bodies close enough to cut some piece from. e.g. the forward edge of the rear fenders where the factory plastic spray guards go...

I cannot find the old threads so starting a new one. Tags: top seal, top gasket, camper gasket, fiberglass top seal I have my top off all summer. Old seal had shrunk and deteriorated. OEM is no longer made. I check with numerous dealers and could not find one. I found this substitute. Will...

Check ebay. I actually sold my 89 set for quite a bit of $. Just make sure the holes are in good shape. As an alternative, you could buy some rubber and cut out your own. Make a template out of plywood so you can cut out an exact pair. Punch the right size holes with a shell case or piece...