Recent content by myf16

I found a 4th gen tray on eBay. It fit perfectly, but damn that 27F battery was really hard to lift out of the vehicle. No handle on the 27F and it's HEAVY. I'm very happy with my new setup.

I just installed a 27F in my 2011 4Runner. I removed the old 24F battery and the plastic tray. The 27F fit on the shelf with no difficulty at all. I plan to install a larger plastic tray under the battery later this year. Maybe I'll find one at a salvage yard.

Does this post help? https://www.toyota-4runner.org/2429272-post14.html

Thanks. Was it from a Yukon XL or non-XL?

I recently added a Gobi rack with fairing to my 2011. No lights on the rack. I'm going to park it for several months and I'd like to buy a car cover. The fit does not have to be perfect, but a standard cover will be too small. Any ideas what cover I should buy?

I'm looking for a fluffy-soft custom fit cover for the 2011 4Runner. I don't mind if it gets wet as long as it dries fairly quickly. I mainly want to limit the dust accumulation so I don't have to wash the vehicle as often. (It's black.) Can anyone here recommend a cover?

I just replaced my liftgate switch. I wish someone had posted that the top of the garnish pulls straight out because I broke that part lifting up and out. I glued it back together and it seems fine, but still. The other surprise was that all six nuts holding the garnish were less than hand...

I have an SR5 non-Trail 2011 black inside and out. I would like to have a cargo tray. If you would prefer not to have your cargo tray, we can swap parts. I'll throw in a reasonable amount of money or complete the swap on both vehicles so you don't have to lift a finger. I am located in Sonoma...

I have an SR5 non-Trail 2011 black inside and out. I would like to have a cargo tray. If you would prefer not to have your cargo tray, we can swap parts. I'll throw in a reasonable amount of money or complete the swap on both vehicles so you don't have to lift a finger. I am located in Sonoma...

I was completely wrong. First, the diameter is the same. The difference between the two part numbers is the placement of two strakes on the connector. One part number is used for the rear washer pump and the other for the front washer pump. Presumably this arrangement prevents interchanging the...

My old pump is 85330-60180 and the non-OEM part is 85330-60190. The wedged ring of the 85330-60190 that has to enter the talk is slightly larger in diameter than my old part. On the other hand, I have no idea if there was any difference in diameter between the original 85330-60180 and the...

It turned out the neck was not fully inserted in the bottle (due to the accident). I didn't realize it was a 2-piece bottle. Now it no longer leaks. But both pumps make noise and neither one shoots out water. I get the same water flow with the pump on as with it off. So I need 2 new pumps. Are...

My 2011's windshield washer bottle has a massive leak due to an accident. I've searched unsuccessfully for instructions on how to remove it so I can repair it. What are the main steps for removal?