Recent content by Mzs14

Hmm, in that case it may just be the nature of that supercharger to run like that. I should note my supercharger is the black 2nd gen so it's not a direct comparison.

When you say it was rebuilt do you know if the rotor pack needle bearings were replaced or if it was just the nose cone that was rebuilt? That noise sounds like it's the needle bearings to me. I just finished rebuilding my supercharger completely and cured the box of rocks sound at idle 100%.

I just want let you know that I am super pumped to follow the shop build out and all the sic mods it will yield. I had been looking for a similar real estate upgrade in CO but found myself completely priced out. Thanks for allowing me to live vicariously through your journey!

These are sold.

After my last IK22 change I went down the spark plug rabbit hole. If I am not mistaken we should be able to run either of these plugs given that they are the same heat range 403 Forbidden or 403 Forbidden I haven't pulled the trigger on either yet but want to in the next 10k.

I have had the same experience. The cost and labor of replacing the seat covers again, even with me doing the work is daunting.

Thanks for the picture, that looks perfect for my needs.

I am interested in this for sure! I have a saved 80/20 extrusion cart with everything else waiting for something like this. Is the length of the side rails meant for the stock rail length?

I've often thought about this as well. There is what I believe to be an example of this up on craigslist currently 1998 Toyota 4Runner SR5 - cars & trucks - by owner - vehicle... After seeing it it could still be an option if it were tucked closer on that example but the exposed quarters kind...

No complaints so far, compared to more overland marketed awnings this is some of the best bang for your buck.

I bought the NAPA awning and drilled through the stock cross bars. Everything clears and should work just fine.

That looks like a really smart tire/bumper solution. If this was available for mass production it would likely sell fairly well. Any particular reason you went with a center mount location on the tire carrier as opposed to offset to either side?

PM sent.

New Energy Suspension complete rear control arm polyurethane bushing kit $35.00 picked up or buyer pays shipping.

All parts are new w/hardware and were purchased from the Retrofit Source: 2x Ballasts 2x 4300k H1 Bulbs 2x Bi-Xenon projectors 1x Bi-Xenon harness to run both hi/lo projector functionality 2x MCR shrouds SOLD [/url] [/IMG]