Recent content by Natsirt

  1. N

    Official 3rd gen 4Runners on 35's Pic Thread

    3.5" (ish) suspension, no body lift, no rubbing Rolled rear fenders and fair amount of massaging up front but they fit and no rubs
  2. N

    Anything I should know?

    I'm in Vancouver BC. Lucky out here in that the weather isn't usually extreme enough to need much salting on the roads. I did look at a handful that were pretty rusty though so I was definitely lucky to find one this good. I'll post pics when I get a chance. Have to figure out what the first mod...
  3. N

    Anything I should know?

    I picked it up this morning. I went over it for quite a while looking for rust and found little to none. Timing belt and water pump have been done in the last year. It's really clean inside and out. The only thing I've noticed is that the oil pan gasket is weeping a bit. No drips really, just...
  4. N

    Anything I should know?

    Think I found a good one but I would appreciate your opinions. 1997 limited 178,000 km's (roughly 110,000 miles), v6, auto, rear locker, no rust, no tranny fluid in the coolant. Looks and drives great. $8500 Canadian. Thoughts?
  5. N

    Anything I should know?

    Thanks again for the input. That buyers guide will be very helpful
  6. N

    Anything I should know?

    Cool thanks. I forgot to add above that I will definitely get a 4x4 as well. Good to know about the newer ones too
  7. N

    Anything I should know?

    Hi there, New to the forum and in the market for a new vehicle with a 3rd gen at the top of my list. I'll be looking for a 3.4l v6 auto. I was a mechanic for years so i know what to check from that standpoint but what I'm wondering is if there is anything specific I should be looking for...

Members online

Forum statistics

Threads
278,312
Messages
3,554,083
Members
248,016
Latest member
Advally Service
Back
Top