Recent content by ncflyer

Still available if any interest. Will check back more often $30.00 shipped US.

bump - $30.00 shipped. So free with some $ covering getting it to you.

bump

bump

bump

bump

I took out the carpet but left the foam in when I had it in. Made it about level with the top. Just made a couple holes in the foam and had to cut out holes through the metal base by the rear to access the threaded holes for the bolts by the hatch if one wanted to use them. Front is bolted to...

Don't think I have any with just the plate but you can get a good idea from these I took with the drawer system.

Got this for the delta joint mod when they first came out for UCAs and used once. The press adapter tube was modified to work with the standard press clamps that can be rented from auto supply store (too long otherwise). Also have the protector caps that were never used. At the time they had...

Pulled off a 2019 and sold a while back so seeing if any interest for replacement/project. Full valance with all the clips, no cracks or damage other than small rock chip areas little scratches but overall good shape. In NC - $30 shipped.

bump

bump

I had cut this a little to mod for an sPod and replaced with new when I sold vehicle. I cut a center area out where the switches are but I think they'd still work, just no side catch for a couple. Panel in great shape and otherwise stock. Has all the pink/white rear tabs for install. $30...

It's made from Baltic Burch, cut to fit over the front tiedowns and goes to edge of rear trim at rear hatch opening. I put a couple or so coats of spray liner top and bottom. In the pic, the circles are just imprint of round bases from a storage set up I had on it. No damage/indentions. The...

Still some sort of leak? Hadn't seen any issues after the warranty swap and has been mostly sitting in a garage since. I drove it about 300mils or so and though not slinging grease or dripping, did find "fluid" grease on skid and around boots were wet. Looks like a coating but no obvious...