Recent content by nhagon

Great thanks! So: step one: while vehicle is on the ground, remove lower bushing clamps on both sides. step two: place jack under the piston on either side of the sway bar to keep it from extending step three: lower sway bar by? lifting one side or simply letting it drop a bit? step four...

Do you know the torque specs for the clamp bolts by chance?

thanks, for the rear, you support the piston by dropping the bottom clamps on the piston side and the putting a jack under one side of the pistion to avoid the bar, then remove the bottom clamp of the other side to drop the sway bar? Also if lifting one side will it create an angle or more...