Recent content by niccuhles

This the cornfed 1” which is pretty much the same thing as the toytec.

I honestly didn’t notice any improvement over stock, I adjusted them according to the stock arm length and really haven’t touched them since. The rears didn’t have any issues with alignment whatsoever so I never messed with them. It does look awesome though haha. Make sure to use a good amount...

Thank you! The spacer lift is so so, and that’s the reason why I’m looking to upgrade. There’s a ton of nose dive while hard braking right now and I hate it. Nitro ridge grapplers have been awesome, I recommend them for a daily tire. Between the lift, tires and the gobi rack I’m getting 14-15...

My “OEMplus” Pro...

Hey all! I haven't posted any pics of my rig recently and got some after getting it detailed. Mods: Daystar 2.5/1" spacer lift. 1.5" wheel spacers. 285/70/17 Nitto Ridge Grapplers. Icon tube UCA. Icon rear trailing arms. Gobi Stealth rack and ladder. NFAB nerf bars. HIDs and LEDs swapped...

TRD Pro Suspension I will be upgrading my suspension in early January so kinda putting this up for a feeler. Looking to sell my 2016 TRD Pro suspension with about 16k miles on it. Will come with Daystar 2.5/1" inch lift spacers. $950 + shipping. Also looking to sell my NFAB nerf bars also, $220...

Just a 1" cornfed front lift spacer, as far as height goes. Icon upper control arms and rear trailing arms.

Ive ran both 285/70/17 Goodyear Duratracs and Nitto Ridge Grapplers. You'll need to remove the mudflaps, trim the bumper and push the fender liner forward. I didn't rub on the body mount until i added 1.5" wheel spacers. Duratracs: Ridge Grapplers:

Looks good! Im assuming you didnt use the NX2 rear shocks and stuck with the Pro shocks?

Looks good! I did a 1" CF front lift spacer on my Pro and now you have me contemplating on jumping to the 2/1"...:Cry:

No issues so far. I'm running a set that I bought on amazon. I originally wanted spidertrax but they only make them in 1.25".

Im running 285/70/17 Nitto Ridge Grapplers on stock TRDPro wheels and 1.5 inch wheel spacers. I rub slightly on the body mount right now. I also have Icon UCA so I may try to get the caster set forward a bit to see if I can get the rubbing to stop. :AK47:

You're more than likely rubbing on the front bumper and liner. Trim the bumper and push the liner forward and you should be good.

I'm only running a cornfed 1 inch front with 285/70, all i had to do was trim the bumper. Suspension feel and performance has not changed at all. This pic is after adding 1.5 inch wheel spacers. I had to modify the front liners and trim more bumper, but it now it slightly rubs on the body mount.

It'll fit. I only did a 1 inch front leveling spacer and my 285/70/17 Ridge grapplers fit, youll need to trim the front bumper a bit.