Recent content by nj05mcs

Listen, I'm not saying this is the be all end all this is what you should do or die. I'm simply just stating what has been said by EVERYONE in this thread. As I took the advice from the people earlier in this thread. I was told the middle clip( 3rd clip) labeled 1.25" got you 2" of lift, and...

You seem to be the only one that achieved that then. I'm on the third clip (right in the middle) and got 2".... As did EVERY other person in this thread. What toytecs website says is no different then what bilstein says.

Those measurements are after settling. Read through this thread and you will see everyone gained more then bilstein advertised even after settle. I'm on 3rd clip. Supposed to give me 1.25. Ended up just about 2" of lift after 2k miles.....

Top notch will get you 3" without a spacer. Everyone is getting 1/2" to 3/4 above bilstein advertised height.

Ok so I promised some pictures, however it is dark out. But I will post some feedback and alignment sheet. I had a professional 4wd shop do the install because they have taken very good care of me and many fj members before. 1. For everyone on the forum that say the factory UCA's don't have...

Carrera, i saw you commented on my post in the 6112 thread about factory UCA's are GTG. This thread seems to show otherwise, lol. Did you ever find a remedy for your UCA's or alignment? what was the final judgement?

Yes that's exactly what I meant. Essentially should compensate for lean in the rear.

I was Intersted in the ome trim packers as I ran them on my fj. Considered it, but once again I saw a few guys say that the lean goes away after the 6112's I believe there is a guy on here by the name of cowtown who was using ome spacers in the rear for a small rear lift to add some rake. His...

Hey saker I apologize for lack of details. I know I also asked you in your build thread but just trying to clarify. 2016 4Runner trail premium. In terms of heights and specs being different, that was mainly toward everyone's heights both baseline and post lift seem to be a little different up to...

Ok, so after reading this thread over and over about 6 times, I have come to the conclusion that everyone's setups have come out a little bit different regardless if they are using the same setup. I am tackling my 6112 install this weekend and seem to be torn between the 2nd or 3rd clip setting...

Ok saker. Have been lurking your build for a little bit and the truck is beautiful. Like you were, i am on the fence about 6112's and which circlip setting. Do you have any after measurements? from early spring to late fall i have a 70lb (when its unloaded) bike rack on my hitch that stays...