Recent content by noahwass

I purchased a new vehicle that had this set of tires and have changed the style of the look on the car and do not need these. As best I can tell, the wheels are 22" (certain) Black Rhino Morocco's (pretty certain). The lug spacing is 6 x 139.7 (Toyota/Lexus). The tires that are mounted are Nitto...

When are the Blitz sliders going to be available for us 4th gen guys?

PM sent.

If this trailer hasn't sold yet, you should post it over on the overlandbound.com forums. There would be a lot of interest for this there. Good luck!

JVC8790, exactly how I feel! Too many of my searches have ended in dead ends. Not on my watch! :-)

I got it off! I wanted to clarify the steps that I took so that others can hopefully find this in the future. To be clear, I had the top nut completely removed (that was easy for me), the strut was not binding the post (I had it moved to the outside of the frame so that it wasn't hung up on...

Thanks for the responses, everyone! Thanks, JVC8790 for describing exactly what to cut off. :doh: I'll get out some cutting wheels and start into it. I don't have any sentimental value to the strut itself. I'll work towards getting the strut and the gasket around the bushing removed. Once I get...

As you can see in the photo, the axle bolt is off and there is no gap between the strut sleeve/bushing and the axle mounting post. I've been beating on it for a while and am not getting anywhere. Does anyone know what will happen if I cut the rubber bushing at the base of the strut? I'm not...

Alright fellas, I'm nearly done putting on my new suspension (Dobinsons) kit, but the GD passenger rear strut refuses to budge off the mounting post (see image). So far, I have tried the standard pry bar, a 4-pound hammer and metal pipe placed against the bottom of the strut under the axle, and...

No worries! It should actually by CoG and it's short for Center of Gravity. This video explains how it applies to offroading in case you need more info.

This is a really cool design and I'm all for something designed specifically for the 4th Gen. I could see prototype costs bring around $600. Hoping the manufacturing costs get closer to $350. Any consideration of making these from a different material? Seems like a polymer would be plenty...

I think this is a great looking snorkel for the 4th Gen. Thanks for the pictures! Sent from my Pixel 2 using Tapatalk

Exploring East of Yacolt Burn area in SW Washington. Sent from my Pixel 2 using Tapatalk

How much are you looking to get paid for these? I'm looking for the 302's, but may be interested if the price is right. Sent from my Pixel 2 using Tapatalk

Bump Sent from my Pixel 2 using Tapatalk