Recent content by norutah

No experience with either, but both are great companies. Not sure if you already looked at the ironman. +4° camber built in, non adjustable. I put some on the FJ last weekend along with Eibach stage 2 coilovers and fifth gen 4runner brake swap. 60mm Dobinson dust caps for the arms perfectly...

I typed that incorrectly. The motion ratio is 1.67:1. Unrelated but related. I just came in from installing the Eibach load levelers and bumps in the rear. Very happy with the ride and performance. Sent from my HD1925 using Tapatalk

Thanks for the info, I'll check it out Sent from my HD1925 using Tapatalk

Yes, you will not have an issue. The motion ratio on your suspension is not 1:1. I believe it is roughly .67:1 Sent from my HD1925 using Tapatalk

A few days ago I added an 07 FJ. The previous owner did a fair bit of work to it. I replaced the spacer lift with eibach coilovers and sway bar relocation. Next up is tending to the surface rust on the under carriage and finishing off the suspension upgrades/maintenance Sent from my HD1925...

The Subaru ascent has a GVWR of 6001. Is that close enough to your mandatory GVWR? It has everything that a 4runner lacks and lacks everything that makes a 4runner a solid choice for some people. Some highlights from your list above include: Nice seats [emoji736] Nice colors [emoji736] Sent...

Update, 16 in stock and no longer on sale Sent from my HD1925 using Tapatalk

10-21 4Runner Eibach 2.0 Front Coilovers (0-2.5") 10 in stock and 15% off Sent from my HD1925 using Tapatalk

2005 outback and 2015 RAM dually to haul the toys. Patiently awaiting delivery of the Speed SXS Sent from my HD1925 using Tapatalk

Good question for sure [emoji1303] Sent from my HD1925 using Tapatalk

Yes, the center to center bolt measurements were the same. In the photo they were not aligned right so it looks a little deceiving. Second question, yes. I marked all of the assignment cams, so I could at least get back to stock settings. I lowered the vehicle and rolled it back and forth a...

Just wanted to share how I got my hands on the eibach 2.0 coilovers. I am not happy with the vendor because they list them as confirmed fitment for 2022. Dave at Eibach said this is not true, and they have not even had a 22 in their shop yet. But, to help out anyone that's looking. I went to...

It's done, level, and rides incredible. I ended up using 2 1/4 pin punches. One long and 1 short, indexed as close to diametrically opposite as possible. I lowered the spring seat by 1 full inch. Final measurements are: front wheel arch to top of wheel 13". The rear is 13.25". The bottom of the...

Thanks, I'm heading out to try it again. Funny, I was watching the video from eibach and their wrench appears to have been fixed. You can see it was welded. Or perhaps it was before coating Sent from my HD1925 using Tapatalk

Thank you, Zlots. Did you adjust the front spring seat on the vehicle? Just grabbed the spanner and turned the seat? Sounds like a dumb question but I was pulling with everything I had, and they barely moved, like maybe 1°, before the pin sheared. Nate Sent from my HD1925 using Tapatalk