Recent content by nvwiggins

Got back from King of the Hammers and mounted up an old take off set of 35" Toyos from my Tundra onto the Robby Gordon beadlocks. Front fiberglass makes the 35's look pretty small.

Ford 302 [emoji1360]

Thank you! I have Rhino Rack tracks mounted on the top and each side rail of the rack bolts to those tracks in 8 places.

Mine is a V8 swap with zero body lift, but I don't think mine is the one you're asking about haha.

Thank you! Right now it's on 285/70-16, after King of the Hammers it'll be on 17" Robby Gordon beadlocks with 35s.

Got around to building a roof rack for mine. I'm not a fan of the huge Yakima and Thule racks on the 1st Gen 4Runners. I think they sit up too high and are pretty wide for the small cab width.

Not much new lately, but I did get around to building my own roof rack. Always hated the way that the Yakima and Thule racks look on the first gen so I wanted a low profile strong rack.

Gps antenna for an older Garmin. I keep it in the 4Runner because my speedo is way off so the gps becomes my speedo and odometer on longer trips.

Yeah I have a pickup with a 22r and driving it after the 4Runner leaves a lot to be desired. Then I drive my 15 Tundra and it's like a rocket compared to either one of them haha.

A few things have been done recently but nothing major, mounted rear shocks, swapped the Raceline wheels for Methods and bfg ko2's, worked on the rear bumper, made seat mounts for the beards, had a front driveline made, and been driving it.

Had to run out and test the new front driveline on the ol 1st gen.

Finally installed my wider rear axle, and Explorer leaf springs. Waiting till Monday to get an extended brake line made and hopefully mount some shock on the back of this thing.

Yeah there are a few more recent updates, I don't always post on here as it's not super active compared to yotatech. Regardless recently I installed some TG 3" HD springs I got of a local forum and some 6" shackles we cut out at Relentless Fabrication. Driveway flexing haha had to do it...

The motor mounts are from northwest off-road and the adapter was made by advanced adapters but I don't think it's made anymore, might have to call them and ask about it. I know one is still made to adapt the 302 to Toyota transmission.

The Pick N Pull gods were good to me yesterday, got a double stack center console and a clinometer! Pretty stoked on the clinometer score!