Recent content by Off-Camber

Mine is quite as can be. Hopefully it doesn't start whining down the road.

For those looking to re-gear. I'm sure others have posted but figured I would add my review. Vehicle: 2012 4runner with 3" Dobinson's lift, extended travel front and Long travel progressive rate coils rear on 275×70-17s. Dual swing out rear with about 700-800lbs. Front bumper with accessories...

For Sale in Norther VA DC MD area. Selling for $200obo. I'm working on getting pictures posted. Please Pm me for the time being. it looks like all my jpgs are too large. This is a USA Made Serialized Titan Fuel Tanks brand Trail Trekker ii Spare fuel tank. This sale comes with all parts. Tank...

This is interesting to read. I had Dobinsons UCAs for a large number of miles. After several suspension component upgrades and an alignment, I got a clicking noise in the front left side of my 4runner that I couldn't get diagnosed. I finally thought it might be a bad bushing in the Dobinsons UCA...

Mine chips very easily and always rusts underneath which is what the zinc pre-coat should fix but doesn't. Eventually I'll get it powder coated locally. My local powder coater has zinc metalized then 2 stage powder coated matte black a front bumper and several small home made brackets and it...

2 pictures attached. Hope that helps. Brandon

The spare will still fit in its factory location. You will probably have a little more tire visible from the rear because the Victory bumper is cut higher. I don't have pictures at the moment but could get some later today when I get home from work. The will just be open space pictures, though...

I have a 23zero Peregrine passenger's side 270 non LST awning with all parts on great condition. I would like to trade it for a 23zero Peregrine 180 awning also in great condition. It has been mounted for roughly 10 months before I pulled it off. It has been opened a handful of times to show...

Rear end update. If anyone is looking for a nice place to mount a shovel and or Axe, etc it will fit behind the swing out with quickfists. Just drill a couple of holes and throw some black spray paint on there for prevent rust. Left side carrier will eventually get 2 x 3gal roto pax and 2x 2gal...

I had the same issue. I reinstalled the top plate 3 times pulling it rearward as hard as possible during install but it kept rubbing on the right hook. My OCD kept kicking in until I finally tried loosening the hinges based on the above post as it sounded super easy. Unfortunately it only got...

Hopefully these all come through. Both mounts are at Zink Primer/Powder Coat now. should have them back in a week. I have 1 more mounts I'm going to have to make when I switch out for a 60" hi lift instead of 48". Brandon

Hi Stephen, I have a limited. Are you asking for pictures around the edges of the vehicle where there is a gap between the bumper and bumper cover or around the back-bottom of the hatch area where the flat top of the bumper meets up with the plastic bumper cover area? Brandon

No. I never did as far as mounting it to the bumper. I went to a local metal fab shop and had 1/4" steel plate bent at a 45* angle so I can hang it off the side of the prinsu rack. That way I can still mount up the RTT. On the left swing out I'm going to use the vertical rotopax mount. Plan on...

Does anyone have the Hi lift Jack carrier? I would like to know the overall width measurement as well as the measurement from the left edge of the mount to the start of the bolt slots on the back of the mount (where you bolt it to the swing out). I'm pondering this idea of drilling 2 holes on...

Has Dobinsons Direct changed to Exit Offroad? Or is it just another website run by Dobinsons to gain more market exposure? Basically, where should I go to order parts direct from Dobinsons without going through a outside vendor?