Recent content by One_96TR4

Sold!!!!!

I have a brand new set of Performance Products Lowering Springs for sale. Bought them for a limited I picked up and had plans for but ended up selling the vehicle back. Looking for 200.

^^^ Your also in a '10 versus VOLSFAN's '99 4runner. that will make a difference for sure. My '96 gets about 375-400 on a tank of regular. I used to be able to do 400 easy on a tank so I'm curious to see if it changes as the weather gets warmer. We'll see i guess.

Yes I'm pretty sure he still makes them. I haven't spoken with him in a while but he's still doing them. His e-mail is above.

4x4v8 4th & 5th Gen- Howie (Toronto) AlexJet Heavy modded 4th Gen.- Alex (Concord) One_96tr4 3rd Gen - Omkar (Brampton)

I need to get my rear wheel bearings/axle seals done. Well its reall the bearing but while I'm in there I figure I might aswell do the seals. My issue is I can't find a machine shop that knows how to remove the abs ring. I'm not even sure anymore if it can be done without having to replace that...

FS Brand New Tokico Trekmasters I have a set of NEW tokico trekmasters. there still in there boxes. I paid 370 looking to 340firm.

If your still looking I know a few places that cacn do a 2-way alarm/starter installed for less than 500. PM me.

should be fine...most states and provinces have less strict emissions for diesels or none at all. If you do the swap, keep us posted. Not many have done it.

If you have rear heat there could be a small leak in the lines running under the truck. I had this issue and never noticed anything on the floor pooling but the lines leaked very slowly. I guess over the years rust just got to them.

Have you mechanic look at the front end. Tie rods inner and outer and the ball joints upper and lower. They can check to see if they need to be replaced. Not very likely. These parts seem to last a long time on these trucks. My 96 is now getting the original ball joints replaced. As for the...

Hey I would recommend just doing a drain and fill. Yes it doesn't change all the fluid but you can do it again in a few weeks and it gets most of it out. My uncles been doing transmissions for a little over 20yrs now and he always recommends to do a drain and fill for a car with over 60k miles...

Yeh i guess I didn't really look and notice that he was at 2.5" already. 3" is really all I'd push it in the front for the sake of the cv's. 1" body lift wouldn't be too bad.

I had an issue with mine sticking and not working all the time. Sometimes I would open my hatch and have to sit there slamming it shut for 5-10 minutes until the latch clicked back and would hold it shut. I open up the back panel and lubed it up and its been working fine for the last 3 months. I...

This is my truck with 20% tint over the factory. Not the best pictures but this is what I have on hand. I don't really have any pics of the truck just sitting in my driveway :D .