Recent content by OrdnanceMarine

Finally got around to doing this after the parts sat on my garage shelf for 13 months. Used the Cardone with the heavy duty boots and OEM inner seals. Thanks for the various pointers from everyone in this thread. Had no problem tapping the shafts out of the differential with a long large flat...

I searched on this thinking it's got to be something someone else has seen and dealt with but to no avail. My 4Runner just started acting a bit odd in that when I cross the speed where the doors auto-lock they lock once and a second later they lock again. Never had them do that before. They...

Have Cooper replace the one that won't balance. They should back their product. Let us know what happens and if they treat you well, kudos. If they don't, then we know what to watch out for. I have towed my 14' landscape trailer about 2500 miles and my 16' enclosed trailer about 3500 miles...

As an engineer who's worked from the aero side AND hands on with tuning smaller displacement auto engines (mostly the incredible K20Z3 engine that came with the previous generation Civic Si) I can say that you can assume NOTHING about changing the induction system in any way! You HAVE to test...

By the way, found the rear liners on Amazon for just under $15 each with prime delivery. Went that route for simplicity and time's sake as I've got more projects that need my attention that I can possibly tackle so time is at a premium.

Going to need these very soon so I spent the time pulling up the part numbers from the site that was referenced earlier in the thread. Anyone have any other recommendations on where to pick up the parts? 5373635150 Left front shield $20.34 5388635020 Left rear shield $18.05 5373535150 Right...

Can't be long before every owner comes across needing to replace these! There wasn't even enough parts of the liner left for me to template and what was left crumbled once I put hands on it! I tow a lot now and thought it was the result of my underhood temps being higher for longer than the...

I was up over 3" using the 5100s on their lowest setting and the OME 884 springs (5100 and Superflex in the rear) which was completely contrary to what OME says the lift would be. It's been two weeks since I made the change and I haven't measured again yet but I don't think it has settled any...

Isn't that what we should expect people to do when their god is their belly? While they can act as a curb, more rules won't serve to fix the deceitful hearts of men. "In those days there was no king in Israel. Everyone did what was right in his own eyes." -Judges 21:25

I can understand your question if you were looking at buying the vehicle but since you already own it I'm going to suggest that if you're not willing to have a look at your vehicle and if you don't have the ability to discern whether or not you have an aux transmission cooler then you may be in...

Any way to read the article online?

Had my alignment done at my favorite local shop ($50 and the owner does them himself and does quite a few lifted vehicles, lowered vehicles, etc.). Caster was within spec without a problem on my '07 V6 4WD. I haven't relocated my sway bar mounts but will if I come across any contact. Lift is...

I remember where I was when my uncle pulled that one on me. I was old enough (maybe 12 or so?) that I should have known!

Base housing is all but completely gone, some new buildings on the base have been built (mostly the last 5 years) and we actually have a Home Depot and a Walmart, but I'm guessing there's not that many more people here than there were in the '60. Lots of dirt and rocks to play with down here...

These are the Trillion Dollar Bills I carry. The video gives a good illustration of what one trillion dollars in one dollar bills would look like, how long it would take to earn and how many trucks it would take to move them. https://www.youtube.com/watch?v=RXjgE9-In1M