Recent content by Pete4Run

Spidertrax wheel 12mm to 14mm conversion adapters Got a great deal on some 2024 Lands Cruiser 18's with Michelin tires and I am researching what I need to do to fit them on my 3rd Gen 01. Current setup is KMC wheels with Toyo Open Country RT 275/85/16 but these are quite slippery on wet roads...

Toyota parts website Anyone else notice that since around May 2023, it's impossible to click on a diagram and find the parts for 3rd gen 4runners? I assume it is the same with other models as the parts site went through a complete "rebuild".

Same

Sir, you are a genius! I measured the part of the ball joint where the tie rod end connects to with a caliper and it measured around 17-18mm on the driver's side. The passenger side measured 10.5mm. I compared with my 98 4runner and both sides measured around 10mm. So Jim Ellis Toyota in...

Question about Tie Rod boots New member here. On my 97 4runner, I replaced a bunch of steering rack components ( Steering Rack and Pinion, sway bar bushings, lower ball joint, upper ball joints, sway bar links and tie rods), all oem. On the driver side tie rod end , I noticed as soon as I...

Bell Housing is cut New to the forum. Bought a fairly abused 1997 4Runner Limited 4WD V6. Noticed that PO cut a rectangular piece on the bottom of the transmission bell housing about 3 inches wide. No idea why other than I guess check the torque converter without taking transmission apart...