Recent content by Phpate

Yeah, I always used Google maps instead of Apple maps. No issue there. As far as steering wheel controls, I don't have the phone control buttons, but the "next", "previous", and "mode" buttons all worked with the w4400-nex.

I installed the pioneer w4400-nex last September, and I have enjoyed it so far. It has wireless car play for both Apple and Android. As an added bonus, it also has a detachable face plate for extra security. Was a big selling point for me.

Where did you mount your GPS? For me, there is a little metal plate under the dash where the original gps sensor was stuck too. It's located behind guage cluster to the top right.

I installed this unit a few months ago after a botched break in that ruined my old pioneer unit. Wiring was fairly straight forward, just familiarize yourself with the colors of the factory harness beforehand and try matching wires before splicing. I had to use a different dash kit, and it was...

On the possibility of it being a bad wheel bearing, I did everything I could to verify a bad bearing minus removing it and the only way I could identify it being bad was when I would take higher spend bends in the roads. On a sweeping left turn the sound would go away and on sweeping right hand...

I have the King 2.5 Remote Res' all around, Toytec Superflex rear springs with a 1.5" spacer on the driver side to correct driver side lean. Currently running Toyo MT 275/65R18, but looking at running 285/70R18 in the next couple of months.

Can't believe I've never seen this thread. Hello from Saraland!! (Recently removed from Memphis, TN)

I have the Icon Tubular UCA's and I need to replace the bushings on them to correct an improper install. I've got slightly bulging bushings and squeaking that just won't go away. Will any brand UCA bushing work or should I contact Icon to get exact replacements?

Still don't believe you'd be able to loosen and tighten the adjustment ring with it still being in proximity to the shock tower.

In my experience, adjusting the shock was NOT possible while installed. Where the reservoir tubing exits the shock body, it blocks you from being able to turn the collar enough to grab the next catch point. It was a PITA to get it where I needed it with having to remove and reinstall just to...

Over the weekend I installed a spacer in the rear to help correct my driver side lean where the driver rear side was approximately 7/8" lower than the passenger rear. I installed a 1" spacer on the driver side rear. After installation, the driver rear is still 1/2" lower than the passenger...

PM sent

FS: 4TH GEN Toytec Spacer Lift / Icon Sway Bar Relocate - Mobile, AL I recently replaced my stock Xreas system so I no longer need the spacer lift that I got from Toytec. This is the kit that works with Xreas. You will get the rear spacers, front spacers, front top plate spacers, and the 6...

I recently replaced my stock Xreas system so I no longer need the spacer lift that I got from Toytec. This is the kit that works with Xreas. You will get the rear spacers, front spacers, front top plate spacers, and the 6 extended bolts for the top plate spacer. $175 shipped. Getting ready...

Looking for just the enclosure, not the sub or amp. Thanks.