Recent content by Poe Mans Dream

I purchased one from Amazon made by Thor. It has been great - airs all 4 of my 33" from 20ish PSI to 45psi in 10ish minutes I would say. Its fast enough to be done airing up before you think you would be. I think it comes in at at like 1/2 the cost of the ARB, too. Back when I was doing some...

I was about to pay a shop $400 to do this for me after two failed personal attempts. Timmay, you are a legend.

Any recommendations on places to explore on an east-west coast XC trip? Moving to Portland in the next week and driving from the PA. Thinking of taking 94 to 90 and heading through Montana, Northern Idaho, and dropping down through Washington. Any recommendations on places / routes / trout...

Have done a lot of work over the past 3 weeks - moving from Philadelphia to Portland and I am starting the drive Friday. Had the crossmember that the LCAs bolt to separate from my frame a few weeks ago (lol) - picked up a new crossmember and had a local 4x4 shop weld it in. The fabricator...

Is this toast? Have been looking at local shops vs. SafeTCaps vs. welding in steel plate myself. I am based in PA so not sure if I would pass inspection even with a repair. Thought I did a good job vetting the frame before I bought the truck...wrong. Stay away from northeast frames lol <a...

Need new cats for my 05 v8.. Was looking at Magnaflows but heard the quality is not the best? Also, have DT headers so will need a local shop to weld them in - whats a reasonable labor $ for this job? Thanks all!