Recent content by powderKing

For your needs any of the above mentioned shocks will do you fine. If its driving like a boat add some new springs to. The Old Man Emu 880 spring in the front paired with the old man emu 906 in the rear will put you at the the height your looking for. Since its a highlander model it already...

Test fit these in the stock fog light slot. S1 wide cornering amber. Now to figure out if I want to use the existing pre wiring for factory fogs and get a new stalk with a switch or wire them up my self to a switch in the punch outs beneath the dash hmmm options options options... also got to...

I actually tried this today and it worked, until my belt broke ha it was old and narrow im assuming a wide belt would work better. It turned the filter just enough i could start getting it with my hand.

Oil change, New air filter, and Hit 270K:playball:

Rear Left License plate light bulb Cover and screws please. Dont want a ticket for the holidays. thanks

Im using tundra Billies and the OME 881 500lbf/in spring rate. rides good on the road and pretty smooth of road, little stiff cant complain, but i prefer the little stiffness to get a better feel of the road than having a Cadillac suspension. A OME 882 might be something to consider same...

Though i may retract what i said previously. If i remember right i read some where years ago when doing my lift that the coil seat isolator that rubber thing " correct me if im wrong" there are different sizes. If you are using the original toyota rubber isolator it is to wide for the toytec...

2nd gen tacoma steelies. 16inch 7 in width

Flip the rubber, the groove of the spring end needs to sit in the gap the arrow is point at in the picture above.

Put on my Snow tires with 2nd gen tacoma steelies.

Well picked up the full set of wheels with center caps for 80 . They are basically new and rattle canned flat black, where taken off at 14000miles, driven by an older gentleman on the highway. Some pics.

Wondering if this wheel will fit on my 3rd gen without extras like wheelspacers or triming. Its just the stock steelies from a 2015 tacoma. Found a great deal for a set of them and was going to use them for my snow tires (265/70/16) . I think these are the correct dimensions of the rim (16x7...

I second they are the wrong plugs. You need the dual electrode as said above. I recently changed mine and used NGK wires and plugs and did the wires while I was in there. Super easy and why not because you are already there. Heres the part numbers I used: Plugs: NGK BKR5EKB-11...

Left rear License plate light cover and hardware? Possibly rear licence plate Bezzel?

Thanks. Hub to fender is 22.5" front, 23" rear.