Recent content by proptied

Love them so far. Went with whatever they had already coming off the boat so I didn't do anything custom. Well worth the wait. The sliding action on the drawers is excellent too, even fully loaded.

I run Drifta. Got them from Matt at Kakadu as well. When the fridge comes out I have a nice flush surface. There's little side wings to make it flat across the entire back but I haven't cut mine yet. The table was a huge and valuable bonus.

Adam and his small crew at 4xInnovations may not be #1 at customer service, but they make some great parts at some seriously good prices. It's definitely a give and take... they would have to hire that customer service labor and raise their prices or spend more time with customers and lower...

Got it dirty.

Aaaand... just missed it. :(

I can move it by hand with some effort. I find it easier to take a rubber mallet to the pin to get it to spin. 1 full rotation is 1/8" lift/drop for me. One thing to note.. if it really won't move it's likely the clamp was loosened too much and it jumped threads. So careful how much you loosen...

If they ARE made by Elka and use the same Elka clamp / aluminum body as my Elka 2.5 Resis, I have had complete opposite results from you. I've adjusted mine multiple times over a week and it's been very easy. They've also been through a very salty WI winter and had no issues adjusting them this...

Very true, if there was a sole fault, that would be it. Not sure if Adam is still on T4R. traxman25 Any thoughts?

4X Innovations Skids - Here Real world pics, truck is dirty per usual... Skids are primed in MasterSeries then spray painted flat black.

Hey I've got these installed, in addition to their sliders. I can get some pictures for you once it's daylight. I've been SUPER happy with them.

Ok, thank you for the peace of mind. I don't run much weight up front and haven't seen an issue so I think I'm good.

It looks like you guys updated the front mount on this rack to sit in the channel, is that true? Anything we should be concerned about with the original style? If so, can it be swapped out or did the side rails change too?

Order placed, thank you!

I'm looking for advice on rear springs for a little more rake plus some more comfort. 2018 ORP, KDSS, full Elkas using OME 895E in the rear. Front bumper, roof rack, steel skids (not gas tank), steel sliders. I don't think I'm running much additional weight in the rear with this setup (no rear...

Ah... just barely missed it. Ordered a T4RPAM a few days ago and arrived today.