Recent content by R Marra

Front D Ring Mounts Do you think that these would work with an amped up winch plate? I had tried to search but didn't find anything saying that they would work or not. I wasn't really too sure about the ones that are offered with the winch plate they seem to take away from the whole hidden...

Another parts source Hello, I have had great results from parts.toyota.com, I have purchased a lot of parts over the last couple of months due to my daughters MR 2 Spyder being involved in an accident. The way it works is you order the parts and they send them to a local dealer that you select...

Drivers side ducting I just had that piece of ducting out today. There seems to be a foam gasket on the piece for the left hand vent and the duct were not seated very well. I would take the one screw out and reseat the ducts and that may solve the problem. Hope this helps,Ray.

i would also like to know.

Is it possible that your thermostat is stuck in the closed position

Sub wiring Weaksauz’s, Could you please elaborate on the wiring you did for the subs. I am doing the same thing in my 4 runner and want to make sure my thoughts on the wiring are correct. Don’t want to have a smoke show. Thanks, RayM.

Hello, I am looking for the 5 pieces that make up the bumper center section. looking for decent condition some surface rust ok Thanks, Ray M

Drivers side door gasket or seal the one that goes around the inner door frame

Divers side door gasket Hello, would you happen to have this part. And if so with shipping to 08865 Thanks,Ray

Bumper that is in fact an ARB bumper. It was done by a member on here by the name of Blcktpgsr. He also has a photobucket that you can view showing a lot of the modifications. Be ware there a lot of very cool mods done to his 4 runner.but defenitly worth the read here is a link to his page...

replaced starter Big thanks to Tim for the video would have been tough without it.

fog lights https://www.toyota-4runner.org/3rd-gen-t4rs/67705-blcktpgsrs-97-transformation.ht Hello, This is the only person I can recall that has done it. He also has a photo bucket link in his thread that may have photo's of what he had to do to mount them. i will warn you it is a lot of pages...

Yes they are in fact 16x8 4.5 backspacing

Wait ,What 37's did i miss something???

land cruiser wheels If my memory serves me correctly the wheels are 16X8 with a 4 inch backspace for the land cruiser and LX 450 for the 96/97 models.If you would like I have a set of the Lx 450's in my basement and i can measure them.hope this helps,Ray.