Recent content by rditto

I am looking to trade my truck. My preference is for a single cab, manual transmission, 4x4, but I’d consider either a prerunner or xtra cab but probably not both! Located in Longview Texas. Appx 16,000 per rules My truck is a 2004 Double Cab, completely stock except for Fox coilovers up front...

I needed some headlight brackets for my first generation to GSXR fork swap, so I fired up the computer to model a set, and FDM “3D printed” them. I have an FDM shop set up for manufacturing and processing molds in another small business venture of mine, but want to expand and get as much value...

Yessir I drove it for a couple of weeks after the accident and after I fixed the windshield and headlight. No driveline alignment issues or fluid loss. Just a missing bumper and the radiator mounts/front panel are bent up

Any input?

Edit: I’ve replaced the broken headlight and removed the front bumper since the photo.

Rust free truck. I’ve owned it since 100,000 miles, there are just over 200,000 on it now. It runs like a champ, but was recently involved in an accident. The week before someone hit me in the front bumper/front right quarter panel I was on a 2,700 mile road trip in this 4Runner and it ran...

I almost had a used Shrockworks bumper shipped to Texas from Oregon just before the trip I referenced.. not sure if that was a good or bad move now

Most people don’t care at all but it is a pretty hard to find power/drivetrain combination

Stock UCAs, and steel 15” wheels. They rubbed just a little bit but oddly enough it wasn’t at full turn. No rub going straight or at full turn but in between when the edge of the tire reached out it would clip the plastic part of the bumper and make decent grind but it was always brief and I...

It definitely needs the core support. The fender/interior of the engine bay on the passenger side is punched in as well so it might be tricky to get everything aligned again. Thanks for the input

1998 4Runner 3RZ 4 cylinder 4x4 5 speed manual trans OME lift kit Tacoma ball joint and tie rod upgrades New CV axles Ditched the cast iron header for a better tubular one that won’t crack. Almost new 33x10.50 ko2s Brand new windshield, wipers, and battery Super clean rust free southern truck...

Fb Put me down for a 3rd gen front bumper - FB. Thanks!

Correct, sorry. Left side only. Thanks

One side, either side. I believe ABS/non-ABS axles shafts are interchangeable but let me do some research to make sure. Give me a text or PM with a price + shipping quote when you get the chance. Thanks. (903) 975-0638

Does this truck have ABS? How much for the a rear axle shaft, bearing, drum brake assembly, and dust shield? Basically everything that comes out attached to the rear axle shaft. Shipped to 75701 Thanks Russell