Recent content by reallifedog

Yeah that was kinda strangely worded there at the end. I'm going to be removing the window lock switch and putting new switches in that location. Essentially, this takes the lock button out of the picture and still allows your rear window to go up and down.

Hey Guys, I haven't been able to find a definitive write up on this for the 2nd Gen 4Runners(just 1st Gen) so I went ahead and put something together. I wanted to show how quick and easy it is to bypass the rear window lock button so you can free up a stock switch location, simplify your center...

Part Number: 9031135032

hmmmmm interesting, I hadn't really considered these but might be a good little fab project....

Looking good so far! If you ever get the urge to sell that tire carrier, please PM me.

ah man I cant wait. looks like I'll have two other people riding with me. We're all hammockers too, if that makes a difference.

I'll be using my CB as well.

Welcome fellow Georgian!

Count me in plus a co-pilot or two. Can't wait to get out there and meet ya'll!

I intend to be there if I can ever get the truck to pass emissions!

this is from their website: the far right number is the "o'clock" position of the element clip.

Obviously out of my element here but how close would they fit on a 2nd gen? asking everyone, not just OP

I didn't have this issue until I replaced my A/T cooler. I only lost like a 1/4 cup of fluid and haven't replaced any since it still looked good(red).

Hey guys I have been lurking for a minute but figured no better time than the present to say hey and introduce myself. I picked up a 2nd gen 4x4 sr5 4runner 4x4 3.slo last month and have been nursing it back to business. I have used this community as a resource almost entirely and its helped me...

I am by no means an expert ton the subject but I have been looking deeply into doing the same lift you are talking about. Sway bar brackets seem to be subjective. I am not planning on changing them.