Recent content by rick.louie

Yes they are amber. The squadrons are the SAE compliant and replaced my fogs. If you are getting the LP6's, Lil B's will make the hoop taller like mine to allow for room for the lights so you don't have to modify the brackets.

Build Updates It's been a while since I've updated this thread. I've made quite a few changes. Replaced my Toytec Boss Suspension setup for Fox 2.5 w/ DSC and some Dobinson Rear Springs Replaced my RCI sliders w/ Westcott Design Bolt on Sliders Replaced my front axles with CVJ Axles Replaced...

Wish you were around a month ago. Already bought one.

Thanks. It's getting there. Time and money. It's getting me where I need to go.

Recent Trip Images Here's some new images from some recent outings. New Gazelle T4 Tent

12V and USB Power to the rear Wired up some constant electrical power to the rear to keep the Dometic CFX 50W powered up while at camp. Will install the X2 Power Group 27F AGM battery this week. Hooked up this BlueSea Fuse Block to the Fuse Box with some 4AWG cables and then ran some 12AWG...

DIY C02 Tank Here's my DIY C02 Tank. Found an expired tank on Craigslist, went to trade it in for this 10Gallon tank at the local welding shop - certified for 6 years - added a 150lb regulator, hose and digital inflator - Total price - $170.55. Beats the PowerTank price!

Rigd UltraSwing Hitch Carrier Installed the RIGd UltraSwing Hitch Carrier with the Rago Fab HiLift Mount Also a new Dometic CFX 50 and fridge slide in the back.

Xenon Depot HID's and LED's Added some HID's for lowbeams and LED's for High Beams

Interested in a foxwing awning in grey in the next group buy.

Here's some images taken from my Fall Photography Tour up on Imogene Pass near Telluride, Colorado. Amazing views!

Thanks so much!

Here's something that might interest you! http://www.toyota-4runner.org/4th-gen-t4rs/206985-rci-4th-gen-sliders-here.html

I didn't like the way they fit so I had a bead weld added to them. I haven't had any rubbing issues, but then again I have all aftermarket skids and LCA's plus body mount chop.

I had problems with the LCA as well and ended up putting a bead weld on them to hold them on. Not sure if you can tell from my pictures.