Recent content by Roburban

  1. Roburban

    How to lower seat in 4th gen

    My driver seat has up/down electrical adjustment but my passenger seat does not in my 2008 T4R Sport. The switches look the same on both sides but the passenger side ONLY moves forward and rearward. Is the passenger side broke or is that the way it comes?
  2. Roburban

    Lower Control Arm Bushing Question

    Popping I have some popping at slow speeds over speed bumps and other uneven ground. Sounds like it's coming from the driver side. I noticed a tear in the UPPER ball joint boot. Looks like most/all of the grease inside is gone. Gonna replace it and see if that's the cure. Did you check...
  3. Roburban

    Daystar 2.5/1.5 vs Cornfed 3/2

    Interesting.
  4. Roburban

    Daystar 2.5/1.5 vs Cornfed 3/2

    Measure from the center cap to your fender. Measuring this way takes out the tire size factor. Stock height should be 19". If you have the Daystar 2.5 you should be measuring 21.5". Mine measured 21". W/ the Cornfed installed, I'm now at 22" Maybe I got a bad batch from Daystar?
  5. Roburban

    Daystar 2.5/1.5 vs Cornfed 3/2

    CornStar or DayFed I just pulled out my 2.5" Daystar front and replaced it w/ Cornfed 3" front. I netted a 1" increase by doing so. I installed the Daystar 2.5/1.5 about 3 years ago on my "08 Sport w/ XREAS. In the past 6 months, I noticed the front seemed to be sagging a bit. I measured...
  6. Roburban

    Lift vs ride height list

    Anyone have any Cornfed 3/2 measurements???
  7. Roburban

    AFE CAI Stage 2 SI Cold Air Intake Sell/Trade

    Sorry guys. I ended up not getting the truck.
  8. Roburban

    Daystar installation question. I know, I know...

    You WILL NOT need a spring compressor. At the bottom of that guys post, he describes the difference of the NEW DAYSTAR kit. Here's what he says: Follow Up: I have had this lift installed for over one year now. Nothing negative to report and I do like it very much. No sag, or spacer...
  9. Roburban

    Just removed Hydrocarbon filter

    DING DING DING!!!! We have a winner!!!! :iagree: If you INCREASE AIR, the MAS (Mass Airflow Sensor) MUST INCREASE FUEL!!!!! Otherwise, you're running TOO LEAN which means TOO HOT and things will begin to fail.....warped heads, blown head gaskets, etc. The MAF will NOT allow that. It will...
  10. Roburban

    AFE CAI Stage 2 SI Cold Air Intake Sell/Trade

    4th Gen AFE CAI Stage 2 SI Cold Air Intake Sell/Trade 2003-2009 Hey everybody, I'm picking up my 2008 4Runner V6 4.0L w/ an AFE CAI Stage 2 SI installed. I'm more of a stock type guy so I'm looking to swap w/ someone in Southern California for a stock intake. 4th Gen 2003-2009 V6 4Runners...
  11. Roburban

    Feedback on Intakes & Exhaust Anyone?

    I'm picking up my 08 Urban Runner next week w/ a AFE CAI. I'm in So Cal. For a few extra bucks, I'll swap mine for your stock one. Send me a pm if you are interested. Thanx, Rob [email protected]

Members online

Forum statistics

Threads
278,309
Messages
3,554,071
Members
248,016
Latest member
Advally Service
Back
Top