Recent content by Rodtheviking

I went with a 3/4 alloy spacer from Toytec, you still have to disassemble the shock and spring to change to top mount bolts. Worked well for an extra inch lift with my bumper.

https://www.amazon.com/Skyjacker-SBE702-Extended-Links-Height/dp/B00112G22Q I went with these, nice and tight and sets the bar level with the ground like factory. You have to drill out the bar to 13mm for the bolt.

Hoshi Motors in Boulder, a little drive but worth it.

Mark the lower arm cam bolts and loosen them just enough to push them down out of the way. Just remove the sway bar end links and remove it, you have to pull the brackets anyway to put in the relocation. Now is a good time to just put new ones in. Be careful of the ABS sensor wires, they are...

I went with Max brakes, I got the Elite XDS kit with their carbon pads, so far so good. They were only 98.00 shipped to my door in about a week. Quite an improvement over the stock squishy feeling brakes. Max Advanced Brakes | Your Stop For Everything Brakes

I still had to run a spacer.

kind of looks like a light adjuster.

Nice. I will be doing this but using a 90deg bend to route out out by the tire. It's what I have seen a few do with the 4th gen. Tuck it up close to frame rail all the way to the back and put a 90deg dump on it. easy peasy

Top bushing not there.

I would use the Centric kit with the snap ring seal. 14344074

You are only increasing ride height, not wheel travel.

Correct. Goodridge 2-21186 G-Stop Brake Lines | Autoplicity

I just bleed out each corner as I go along, start with the furthest away first and go until the fluid is clear and no bubbles. I just did front Napa calipers, https://www.napaonline.com/en/p/ACA1797XA. New pads and rotors, MAX Brakes Elite series. 100.00 bucks to my door and nice quality...

It should be closer to a 3/2 lift with new springs, those lift heights are for "stock" or new height. Keep that in mind. I have essentially the same set-up, and that is what I got. If you use the OME (which I would) set the front to "0" and it should be close to level. And the ride is a little...