Selling the stock height struts from my 3rd Gen that I removed when I did my lift. They are Napa brand and in good condition, just not assembled. The previous owner had them put in one year before I bought the runner from them. They only had about 10,000 miles on them. There is no rust on the...
Selling the stock height struts from my 3rd Gen that I removed when I did my lift. They are Napa brand and in good condition, just not assembled. The previous owner had them put in one year before I bought the runner from them. They only had about 10,000 miles on them. There is no rust on the...
If you reboot the leaking cv immediately you should be fine. I have the same setup in the front w/ the 2nd perch too. Both my cv leaked right after I lifted (they were originals though so the rubber was 14 yo.) I pulled them and put in new NAPA cv. They have been holding up fine and I've gone up...
I can't speak to the vibrations you have going on, but if you do replace the cv axles I would only recommend NAPA (new) if your on a budget and don't do alot of wheeling or OEM if you want the best.
I second that. Do not buy anything but OEM. My drivers side lower ball joint just sheered off the other day. Luckily I was only turning into a parking lot so I wasn't going very fast. I had replaced that one two months ago with one I bought from Oreilly's. Thats less than two months from a ball...
Anywhere north of Bangor would be a good place. I went to a place called Kokadjo above Moosehead Lake last time I was home. Once you get up that north there is big timber business, so there are a fair amount of worn skidder trails to go down. Went bird hunting in October.
On a side of a...