Recent content by rtinniste

Ball pean smack around different spots also helps to drool the suspension out and back the nut off a couple turns. But there is a ball joint separator tool autozone rents. Doubt the neighbors will get ticked I can usually get the ball joint to pop within 5 minutes at worst even on my rusty shit...

icon 2.5 ifp coilovers extended travel still have my icons for sale lots of intrest but nobody has come thru not looking to ship unless buyer pays shipping. perfect shape were on my 4runner for about 25k both rebuild at 20k due to leaking passenger side seal no pitting or any defects in shafts...

bumppppp

Passanger side seal started to leak at 25k

Bump trd skid sold Get this stuff out of my garage!!

Email me [email protected] with a zip code I can get a shipping quote today

Ended up trading in my 4runner have the following for sale. Located in Palmdale (So Cal) but can meet in valencia or simi valley on weekends. Easiest way to get ahold of me is to text me I'm not on here much. Prices are OBO 661.466.7017 1. TRD pro skid plate couple scratches no dents all...

these are fronts, rears will be up for sale in a month or two

bilstein 5100 Selling my bilstien 5100's, oem springs, and top hats they are set to 1.75" in perfect shape. No leaks, clunks, ect were on my truck for about 15k miles only reason I took them off is because I got icon 2.5's in a trade deal so it was a no brainer on my end. These are exactly how...

Did a midnight Rowher flats run, went to shoot pictures and on a whim decided to try the rockpile... Made it thru with zero drama didn't air down, no damage, sliders came in handy no doubt.

Life has been crazy new job and working on my chevy and just racking up miles almost to 50k thankfully my commute is 8 miles round trip now vs 160 :crybaby: Almost traded in for a 4wd 2014 tundra platinum Might be getting a set of extended travel icon 2.5 non resi's from my buddies Tacoma for...

Bilstein 5100 all around set to 1.75" front stock height rear Fender liners are pushed as much as possible without removing washer fluid bottle and the bumper trimmed up. No body mount chop as of yet but my 285/70's don't even come close to it. The 305's will need a BMC but I can fit my...

Tried on some 305/70r17's and it got the bad ideas flowing. Looks like all I'm going to need is a BMC front fender liners have tons of room :wacko: Ignore my rusty ass sliders I've been lagging on the scotchbrite and wd40

Enough to lift from the axle and the A-arm's and get my 285's a inch or so off the ground. You would need to buy or make an extension to make it really useful. I'm sure you could make one of these work or just make something along the lines...

Depends It usually stays in my truck 99.9% of the time, the handle is mounted with quick fists to the hatch and the jack stays strapped down with my tool bag in the back corner. The 1.5 ton has a pretty small footprint and weighs maybe 10 lbs at most so it really hasn't gotten in my way and if I...