Recent content by Runnin on E

So it really has nothing to do with the gauge. What you are trying to say (not very clearly) is the CONNECTOR at the fuel tank is the problem because you disconnected it to change the pump. It is spelled GFY.

What does a new pump have to do with your fuel gauge?

It's not too high. You just need a RTT, a skottle, drawer system, a 270 awning, LifePo4 battery system, dual compressor, winch, dual batteries, front and rear bumpers with dual swing outs...ah let's see what am I missing......oh, full skids....ah.....hhhmm that's only about 800lbs ya 37's too

Here are a couple might make the repair decision easier. Just get it done! Just a moment... Rust Buster Frame Repair Kits For 2003-2009 Toyota 4Runner

Joined a different forum and have 25 people signed up for a trail run so.....get out before you can't.

This is what I did also. Now I have a spare set that I already have new ball joints installed. I have an FJ and T4R so it is handy to just swap out A arms for whichever vehicle needs them next. I did have to use a 20 ton press to get those BJs out after removing the A arm. I have one of those...

Im going to ask AI what it thinks about your attitude......oh...the result just popped up.....it said "simmer down" So does that mean Cezar is actually AI? Nicely done Cezar, nicely done.....

How did you decide where to connect all of these mods? Did you guess?

Here it is

Just looking at the Ironman site, they only have three choices for springs so what you have looks to be the best one. Sometimes you just have to go for it and then let the rest of us know how it turned out. You could also contact them and get spring rate info and then compare that to the OME...

It doesn't look like it has been off road, so there's that.....

This one says genuine Toyota, you might be able to save a few $ I did not compare them with shipping so..... 04112-50400 Genuine Toyota Engine V Gasket Kit

Depending on where the vacuum line enters the intake, you would be by-passing some of the important sensors for the fuel injection like the mass airflow sensor the intake air temp sensor and the manifold air pressure sensor. The FI will probably not be able to calculate a correct mixture. I'm...

That's great, I'm sure that trail run will get crowded quickly.....

It's odd that even moderators don't know where to post trail runs....?