Recent content by rusty904

All very helpful info, thanks very much. My truck came with an aftermarket Tach installed, I'm wondering if I will be able to use that same wiring with a factory Tach?

Yeah I never had OEM cargo panels and I got sick of looking. Not sure whether to paint these grey or leave them black.

Project indestructible interior continues. I added ABS panels from key panels. They are kinda pricey but well made.I added a foam seal the edges to thwart rattles and keep most of the moisture out. I also cut a custom load space out using leftover nitrile flooring from my shed. I’m pretty happy...

I'm looking to swap my DLX cluster on my 88 22re to an SR5 cluster. I've found a few write up's on this subject from the early 2000's but all the pics are removed and there isn't much detail. I know the oil pressure sending unit must be switched but other than that, I am having a hard time...

Raptor liner Hit the rest of the tub with raptor liner. Stuff is a ticking time bomb to work with once you mix it. You have to work very quickly to use it all before it gets too sticky and starts tearing apart the roller. Might have to purchase another kit for a 2nd coat to get the texture...

So I have since found out the purple and black ones are diodes but I still don't know how to source the correct replacements.

I haven't started yet, still trying to source the correct resistors. I think the issue is one 680ohm resistor and two of the purple and black "3k" resistors. The 680 ohm is pretty easy to find but the 3k ones I find online look nothing like the ones on the board. Wish there was an electronics...

Pics of the new new tires (again). Pretty pleased with the looks and ride quality so far. Haven’t really tested the traction yet.

I have the same issue with my 88 22re. I’ve been told it’s probably a bad fuel sending unit and that I’d need to drop the as tank to replace it. I have not gotten around to addressing it yet.

Stupid rear power widow no working again,I think I’ve id’d the burnt out resistors on the board but have trouble figuring out how to source replacements. Anyone ever repair one of these boards?

Finally got Discount to swap the 235/85/16 firestones to 265/75/16 Goodyear Ultraterrains. Decided to make the switch to go from an E sidewall to an SL for a better ride. Weight is supposedly the same at 40lbs ea. In the short ride home from the shop, I noticed that the ride is certainly...

Reviving this thread. This stuff is a bear to work with at least for me. I'm trying to get it properly fitted to my first gen and struggling mightily. Having the most difficulty getting the footwells flat.

Holy hell this vinyl floor will be the death of me. Just shove it in, mark, trim over and over and I can’t get it to lay flat. Anyone install this stuff on their trucks?

Started refinishing interior parts with sem classic coat. It looks great and I think is a good match for the original color but the contrast between old and new is so great, I may have to do all the interior plastics!

Molded Vinyl Mats I got the passenger area kit from these guys, on sale at the time dunno if they still are. Molded Vinyl Mats Floors are supposed to be custom molded for the truck but there’s still lots of trimming to do If it all goes well I may do the cargo area the same way. Here’s a...