Recent content by rwelch53

So as much as I loved these DTMoto blacked out housing headlights when I got them, it took 8 months for the clear sealant they use on them to start peeling and look like crap (they said it was delamination lol) and one is letting moisture in now because of it. They said warranty is only 60...

So I've got a set of DPMoto black housing headlights on my '06 and they seem to be peeling, or delaminating, as the company says. They apparently only have a 60 day warranty, so no help there. Anyone have any experience with this? I feel like I can polish or compound this off and then spray a...

I was wondering the same thing. I got 35.5 FD and 36 FP with my 3rd gen Tacoma TRD front swap, but am still debating what to do with the rear as I want a slight rake, but I don't think I want quite that much.

I would grab that for $140 if you can for sure! I rode in a couple 4Runners with 5100's and 2-3" lift springs (Toytec and Eibach I believe) and they rode very similar to my TRD Tacoma setup. If the guy you are buying them from left the fronts assembled, then it is such an easy swap also. You...

This just made me go out and check mine that I installed a month or so ago, and I have them as you said but I still have the damn lean of about a half inch on the driver's side. :censored:

Cool, and I figured for $100 just grab them now and throw them in the storage unit for now until I'm closer to needing new tires...I don't feel as bad if I can get stuff on a deal and do work in stages so the sticker cost doesn't hit me and I can convince myself it is still a budget build. :help:

Do these work this well on the 4th gen V6?

I found a set of the Tundra wheels for $100 local to me, but they are peeling in areas pretty bad. I haven't talked to a powdercoating shop yet, but do these look save-able? I'm assuming they will have to be sandblasted or something to strip them.

Anytime you have an opportunity to add some zipties, go for it...I'm a firm believer in the power and usefulness of zipties for the win! :trophy:

No complaints, and been through many carwashes with them and DTMoto black housing lenses with zero problems.

So I purchased a bunch of lights off Amazon a few months ago including the Auxbeam lows, and have been super happy with all except the Vehicode DRL's for the front. Amazon.com: VehiCode No Hyper Flashing 25W Bright 1156 1141 7506 LED Light Bulb (Amber/Yellow) Kit - 93 BA15S P21W CanBus Error...

So I purchased a bunch of lights off Amazon a few months ago, and have been super happy with all except the Vehicode DRL's for the front. Amazon.com: VehiCode No Hyper Flashing 25W Bright 1156 1141 7506 LED Light Bulb (Amber/Yellow) Kit - 93 BA15S P21W CanBus Error Free Built-in Resistor...

You are almost open to use any speaker because the power put out by the factory amp is nothing compared to almost every aftermarket amp on the market these days. With that being said though, it is important to get a speaker that is efficient so that it will make the most of the little power it...

So I believe the factory amp is a total of 110 watts to the sub (peak I believe, not RMS), but it is using a dual voice coil (DVC) sub, so about 55 watts per voice coil and each is at 2 ohms impedance. Find yourself a good aftermarket shallow-depth sub that will match up and you should...