Recent content by scbrown333

I installed these two months ago and really like them. I got exactly 2” on one side and about 1.75” if lift on the other. I’m thinking about adjusting them a tad higher, but not in a big rush. Curious of others experience as well. Sent from my iPhone using Tapatalk

Washington Cascades Sent from my iPhone using Tapatalk

Jesus... You’re all a bunch of dysfunctional monkeys. Douche-brigade out in full force on BOTH sides. I have the same set up you’re asking about Westex. You’ll end up with a little bit of a rake. I was concerned right after install, but the rear seems to be settling nicely. Still...

Were you able to adjust them without removing them and placing them in an compressor? I have the same situation and thought about adjusting the front to gain about .5”. How much height increase did you get after you adjusted them. Looks like you gained over an inch on the threads, but curious...

Looks good! What did you do to it?

Why not?

Resurrecting this old thread because I'm looking to do the install on this same set-up tomorrow. Fox 2.0 (0-1.5") rear with the OME 2895e springs. I'm curious what you decided to do and what your thoughts are on the set up. I too, had a site sponsor tell me the shocks have enough travel to...

What's the difference between these two? 985-24-117, Rear, w/Res, 0-1.5" - In Stock 985-26-117, Rear, w/Res, w/Adj, 0-1.5" - In Stock Will they fit with the Wheeler's T13 spring...